User manual BROTHER LX-570

[. . . ] The LX-570 is designed for use with items up to five inches wide. It works best with item thicknesses between 20 pound bond paper and 100 pound card stock or construction paper (min. thickness is 0. 010 inches). How to Use the LX-570 the item: 1 Insertthe item face up at the feed Insert deck and turn the knob in the direction of the arrows only; do not turn knob backwards. 2 Cut: the item clears the cutter at the exit When area, gently push down on the cutter knob and slide it all the way to the left or right. When Using the Starter Cartridge. . . [. . . ] Always consult packaging of replacement cartridges. How to Change the Cartridge a 1 Remove the cartridge: the top cover. Then 2 Insertthecartridge: and lower Lift up the latch to open Open top cover grasp the cartridge in one hand, hold the LX-570 with the other, and lift the cartridge up and out. Notes: When placing a partially-used cartridge back in the machine, be sure the material does not adhere to the cartridge itself. When removing a used cartridge whose material has wrapped around the rollers, remove the cartridge and pull the material from the rollers. the cartridge in with the label up, facing the feed deck. As you lower the cartridge, be sure that the backing material fits underneath the cutter bar at the exit area. Close the top cover by gently pushing down until it clicks and is fully seated. Guide the backing material under the cutter bar into the exit area. The cartridge is properly installed when the label is flush with the feed deck. Close the top cover before using. How to Change the Cutter cutter: 1 Unsnap thethumb underneath the back of the Place your place: 2 Snap the new cutter intobar, place the front At any point on the cutter of the cutter into the groove on the cutter bar so the blade fits into it. Then rotate the cutter back and snap down. Front of cutter Blade is at front of cutter. Avoid touching the blade. 1 cutter knob and your index finger on the cutter bar. Lift up with your thumb to unsnap the cutter from the cutter bar. Back of cutter Groove in cutter bar When installed properly, the cutter slides back and forth on the cutter bar. Blade is at this end and fits into a groove on the cutter bar. Always avoid touching the blade. Warnings & Cautions Warnings: Never place your finger under the cutter bar at the cutter. When handling cutters, take care to avoid injury to yourself or others. Avoid ingestion of the backing material or cutter. Avoid contact of adhesive backing materials with skin or other delicate surfaces. Keep fingers out of the top cover when closing. Cautions: All backing materials are permanent once applied and cannot be removed without damage. Once you start feeding an item, do not try to back it out by turning the knob in the opposite direction. Always feed items straight, not at an angle. [. . . ] Do not hold on to the item as you turn the knob; allow it to feed freely through the LX-570. When using the laminate cartridge, air bubbles appear. Turn the knob to feed laminate film until there are no visible bubbles. Or replace the cartridge. Maintaining the LX-570 To maintain your LX-570, clean the cutter, exit area, and rollers. It is a good idea to clean whenever you remove and replace a cartridge. [. . . ]