User manual BROTHER PT-2200

[. . . ] USER'S GUIDE , , , , , , , , , , , , , , , , , , 2200/2210 Read this User's Guide before you start using your P-touch. Keep this User's Guide in a handy place for future reference. INTRODUCTION Thank you for purchasing the P-touch 2200/2210!Your new P-touch will allow you to create labels and stamps for any need. Its versatility enables you to design custom labels by choosing from a variety of frame designs and from many characters sizes and styles. [. . . ] Shorten the text to less than 1 meter before trying to print. Set the label length between 1. 6" (4. 0 cm) and 11. 8" (30. 0 cm). This message appears if the text is longer than 1 meter when you try to print. This message appears if the Length function is used to set a label length that is less than 1. 6" (4. 0 cm) or more than 11. 8" (30. 0 cm). This message appears if the Tab Length function is used to set a tab length that is more than 11. 8" (30. 0 cm). Set the tab length so that it is less than 11. 8" (30. 0 cm). LINE LIMIT! This message appears if the number of lines in the text is greater than the maximum number of lines possible for the installed tape. This message appears if you try to store a text file after 300 characters have already been stored in the memory. This message appears if you try to recall or delete a text file from the memory when none are stored. Reduce the number of lines or install a tape of greater width. MEMORY FULL! Delete an unwanted file to make room for the new one. NO FILES! Store a text file first. 77 Error Message NO TAPE! Cause This message appears if you try to print a label or feed the tape when no tape cassette is installed. This message appears if the number that is set to be printed using the Numbering function is less than the number above the cursor. This message appears if the installed alkaline batteries are about to run out. This message appears if there is a problem with the machine's read only memory. Remedy Install a tape cassette and try again. NUMBER TOO SMALL! Press the key of a number that is greater than the number in the text. REPLACE BATTERIES!ROM PROBLEM! Replace the batteries or use the AC adaptor. Turn off the machine, and then while holding down Align and , turn the machine back on. This message appears if there is a problem with the machine's software. This message appears if 50 tabs have already been added to the Tab Contact your service representative. Limit the number of tabs in the text to 50. text when you press TEXT TOO HIGH! Reduce the size of the characters or install a wider tape. Delete some of the text, reduce the character width or increase the set label length. This message appears if the size of the text is larger than the width of the installed tape. This message appears if the length of the text is longer than the label length that has been set using the Length function. 78 SPECIFICATIONS HARDWARE Input Device: LCD: Keyboard - 51 keys 7 5 dots 12 characters 2 lines 16 indicators Pressure-sensitive, Adhesive-based 26' 3" (8 m) long Five widths available: 1/4" (6 mm) 3/8" (9 mm) 1/2" (12 mm) 3/4" (18 mm) 1" (24 mm) Eight AA alkaline batteries (AM3, LR6), eight AA manganese batteries or optional AC adaptor Auto power-off if no key is pressed for 5 minutes 128 dot / 180 dpi 7 1/2" (W) 9" (D) 2 1/2" (H) (188 234 67 mm) 1. 98 lbs (900 g) (without a tape cassette and batteries installed) Print Tape: Power Supply: Print Head: Dimensions: Weight: SOFTWARE Buffer Size: Memory Size: Character Size: Print Styles: Maximum 99 characters Maximum five lines 300 characters Six sizes (6, 9, 12, 18, 24 and 36 points) + 48 point (Capital letters only) All are available in normal and wide Normal, Outline, Bold, Shadow (each can be combined with Italic), and Vertical 79 ACCESSORIES q Supplies Obtain tape cassettes from your nearest authorized dealer. Use only Brother TZ tapes with this machine. Brother cannot be held responsible for trouble caused by the use of unauthorized supplies. Do not use tapes that do not have the mark. 1" (24mm)-wide laminated tapes TZ-151 TZ-251 TZ-451 TZ-651 TZ-252 TZ-354 TZ-355 TZ-141 TZ-145 TZ-241 TZ-242 TZ-243 TZ-344 TZ-345 TZ-441 TZ-541 TZ-545 TZ-641 TZ-741 TZ-B41 TZ-M41 TZ-WB41 TZ-WT41 TZ-WS41 TZ-131 TZ-231 TZ-232 TZ-335 Black characters on clear adhesive Black characters on white adhesive Black characters on red adhesive Black characters on yellow adhesive Red characters on white adhesive Gold characters on black adhesive White characters on black adhesive Black characters on clear adhesive White characters on clear adhesive Black characters on white adhesive Red characters on white adhesive Blue characters on white adhesive Gold characters on black adhesive White characters on black adhesive Black characters on red adhesive Black characters on blue adhesive White characters on blue adhesive Black characters on yellow adhesive Black characters on green adhesive Black characters on fluorescent orange adhesive Black characters on clear (matte) adhesive Black characters on Bugs Bunny adhesive Black characters on Taz adhesive Black characters on Tweety & Sylvester adhesive Black characters on clear adhesive Black characters on white adhesive Red characters on white adhesive White characters on black adhesive 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 $23. 99 $23. 99 $23. 99 $23. 99 $23. 99 $26. 99 $26. 99 $20. 99 $20. 99 $20. 99 $20. 99 $20. 99 $24. 99 $23. 99 $20. 99 $20. 99 $23. 99 $20. 99 $20. 99 $24. 99 $20. 99 $23. 99 $23. 99 $23. 99 $16. 99 $17. 99 $17. 99 $20. 99 Description QTY/ PACKAGE PRICE 3/4" (18mm)-wide laminated tapes 1/2" (12mm)-wide laminated tapes 80 Stock No. Description QTY/ PACKAGE PRICE 3/8" (9mm)-wide laminated tapes TZ-121 TZ-221 TZ-325 TZ-421 TZ-111 TZ-211 TZ-315 Special tapes Stock No. SK-LB SK-MB SH-LB SH-MB Options Stock No. [. . . ] CHRS! Causa Este mensaje aparecer si el cursor est al final del texto cuando mantenga pulsada Number Remedio Mueva el cursor hasta debajo del nmero manteniendo pulsada Number y presionando . y presione LENGTH LIMIT! . Este mensaje aparece si el texto Acorte el texto a menos de 1 es ms largo de 1 metro cuando metro antes de tratar imprimir. Ajuste la longitud de la etiqueta Este mensaje aparecer si utientre 1, 6" (4, 0 cm) y 11, 8" liz la funcin de longitud para (30, 0 cm). ajustar una longitud inferior a 1, 6" (4, 0 cm) o ms de 11, 8" (30, 0 cm). Este mensaje aparecer si utiliz la funcin de longitud de tabulaciones para ajustar una longitud superior a 11, 8" (30, 0 cm). [. . . ]