User manual BT FREESTYLE 70

[. . . ] Freestyle 70 User Guide This equipment is not designed for making emergency telephone calls when the power fails. Alternative arrangements should be made for access to emergency services. At a glance Handset At a glance Base unit Telephone line cord socket PHONE LINE POWER LINE Mains power socket In Use/Battery Low light Comes on when the handset is in use or, if the handset is on standby, to indicate the battery needs recharging. see page 6 Aerial Does not extend, do not pull out. see page 5 Volume control button Adjusts the handset ringer volume and earpiece speech volume. [. . . ] The rest of the number is dialled. PLEASE NOTE l l To store a number of more than 20 digits ickdia Qu 09 Press the QUICKDIAL button. Press one of the 0-9 buttons to set the location code under which your phone number will be stored. Press another 0-9 button to select a second location code under which to store the remaining digits. The rest of the number is stored. l l l l 09 KEYPAD ickdia Qu You can mix manual and memory dialling as required. The RECALL button, when set to time break recall, is also used for BT Select Services. ickdia Qu l l Press the QUICKDIAL button to finish the setting (you will hear a confirmation tone). If no instruction is received during this process within 8 seconds, there will be a beep and the process will be cancelled before returning to standby mode. 11 Help and advice If you have any problems using your Freestyle 70, this section will give you the most common, easy-to-follow solutions. Telephone problems · No dialling tone. · Telephone cannot receive calls. Possible cause Telephone not connected to telephone line. Solution Replace the handset on the base unit for 10 seconds and try again. If this does not work, disconnect the handset battery from the handset for 10 minutes. Plug the telephone into the telephone line. · Beeps six times and drops calls. Mains disconnected Handset battery is discharged. Connect the mains power supply. Place the handset on the base unit and recharge it for 24 hours ensuring the CHARGING light is on. See page 11 to switch from tone to pulse dialling Use the switchboard/PBX access code. · You have a dialling tone but the telephone will not dial out. You may be trying to use tone dialling on a pulse dialling exchange. You are connected to a switchboard/PBX and are not dialling the access code. · Handset does not ring. · Handset does not ring, a light shows on the handset. Handset battery is discharged. Place the handset on the base unit and recharge it for 24 hours. The handset ringer may be set to OFF. If you connect too many telephones or devices to your line they may not all operate correctly. If your telephone is connected to an extension socket, it may have been connected incorrectly. Increase the handset ringer volume. If the REN exceeds 4 disconnect one or more telephones or devices. Check with your telephone engineer that the extension socket has been installed correctly. 12 Telephone problems · Callers are faint. · Whooshing. Possible cause The base unit telescopic aerial is not extended as high as possible. Radio channel interference. Solution Extend the base unit telescopic aerial as far as possible. Press the CHANNEL button on the handset, to select a clearer channel. Press the CHANNEL button on the handset, to select a clearer channel. Relocate the base unit or move around with the handset until reception improves. [. . . ] They contain toxic materials which could cause injury. · · · · · · Firmly hold the handset in both hands with the back towards you and the bottom end away from you. Push the depression in the battery compartment cover, inward and away from you with both thumbs, to remove it. Undo the plastic belt securing the battery pack. Remove the old battery pack by unplugging the small white plug that connects it to the handset. [. . . ]