User manual BUSHNELL ONIX 200CR QUICK GUIDE

[. . . ] Grayscale Display ONIX 200 / 200CR English Color Display GPS RECEIVER Quick Start Guide Model #s: 362000/362005 Lit# 98-0908/07-07 Thank you for purchasing the Bushnell ONIX Series!The ONIX has been designed to be much simpler to operate than other handheld GPS receivers, while offering exclusive and unique features such as the ability to layer satellite photos or topographic maps (downloaded from BushnellGPS. com) right over your trail map screen, providing a "real world" frame of reference that other GPS units lack. Just press the "hot" button on the top of the ONIX to quickly see your current location relative to the other map elements. [. . . ] The first highlighted item is always "Where Am I?", press OK to see your current location on the map display. This function lines up the GPS position icon ("You Are Here) with the crosshair pointer icon. The next HOT button menu item is: Find/Go To. Click OK or right arrow(on 5-way button) to find or go to any of the listed items (Fig. 15) (note that you can only select from previously stored items, not create a new one, when using the Find/GoTo feature). Selecting any of the items (by clicking "OK") will activate navigation. The title of the selected item will show on the screen, and the bearing arrow will point in the correct direction to take you to it. To stop this navigation activity, press the HOT button again-you will see the option to stop. Press OK to confirm you want to stop navigating, and you will be returned back to the MAP page screen, but without the bearing arrow pointing the way to a specific destination. The available Find/GoTo items you can choose to navigate to are: · Nearest Waypoint · All Waypoints-pick from list of all (closest to furthest order) · POI (Point of Interest)-gas stations, hospitals, etc. · Places-built into the base map-city names, etc. · My Trails-pick from list of saved Trails (see next section). The ONIX will start pointing you to the closest point on that trail (Fig. 16 Navigating to closest point on a saved trail (TraiL #00) 1 The HOT Button (cont. ) A trail is a previously walked path, for example a trail that you took back to your campsite that wound around trees and past the edge of a pond. · My Routes-pick from your list of saved routes (point to point navigation) · My Photos (or Topos)-after you pick a photo or topo from the list (Fig. 20) (arrow down to it) and press OK to confirm you wish to navigate towards that area, the ONIX will begin to point you towards that area. (Note that you must have selected photos or topos as a screen layer in your MAP options as described earlier on page 11 if you want to see it while navigating. ) Alternatively, instead of pressing OK, you can right arrow from the name on the list and go to the "eyeball" icon, then press OK to just view the photo or topo without starting navigation. To exit this "view only" mode, press OK again to return to the list. · Location-manually enter a known latitude and longitude coordinate Following Find/GoTo, the next HOT button menu item is: My Trails. A trail is a path or course that been previously traveled by the user. 17): 1) Start New Trail-press OK-you are now ready to build a new trail, from your current starting point. To end or reverse an active trail, press the Hot button once. Go back into the "My Trails" menu, press OK and you will see the menu shown in Fig. [. . . ] ·Wide Area Augmentation System (WAAS): A system of satellites and ground stations that provide GPS signal corrections for better position accuracy. A WAAS-capable receiver can give you a position accuracy of better than three meters, 95 percent of the time. (At this time, the system is still in the development stage and is not fully operational. ) WAAS consists of approximately 25 ground reference stations positioned across the United States that monitor GPS satellite data. Two master stations, located on either coast, collect data from the reference stations and create a GPS correction message. [. . . ]