User manual BUSHNELL SPORT 600

[. . . ] To ensure optimal performance and longevity, please read these instructions before using you're Sport® 600 laser rangefinder. HOW OUR DIGITAL TECHNOLOGY WORKS The Sport® 600 emits invisible, eye safe, infrared energy pulses. the Sport® 600`s Advanced Digital microprocessor and ASIC chip (Application-Specific Integrated Circuit) results in instantaneous and accurate readings every time. Sophisticated digital technology instantaneously calculates distances by measuring the time it takes for each pulse to travel from the rangefinder, to the target, and back. [. . . ] Once a range has been acquired, you can release the power button. The crosshairs surrounding the aiming circle will disappear once the power button has been released (i. Note: Once activated, the LCD will remain active and display the last distance measurement for 30 seconds. You can depress the power button again at any time to distance to a new target. As with any laser device, it is not recommended to directly view the emissions for long periods of time with magnified lenses. A liquid crystal display (LCD) is mounted within the optical system and when activated, displays unit of measure, a reticle for targeting, when the laser is actively firing, when a target has been acquired, and low battery indicators. inherent in the manufacturing process are small black spots that appear in the optical system. These are a natural characteristic of the LCD and cannot be fully eliminated in the manufacturing process. They do not affect the distancing performance of the unit. a summary of these features is presented below. UNIT OF MEASURE OPTIONS The Sport® 600 can be used to measure distances in yards or meters. The unit of measure indicators are located in the lower right portion of the LCD. To select between yards and meters, the unit should be off. While looking through the eyepiece, press and hold the POWER button down for approximately 5 seconds. during this time all liquid crystal segments and icons will be displayed. As you continue to depress the power button, the display will toggle back and forth between Yards and Meters. Once the unit of measure desired is displayed, simply release the power button. The device will return to the last unit of measure setting used each time the unit is turned on. RETICLE FOR TARGETING OBJECTS Place the aiming circle (located in the center of the field of view) upon a target at least 5 yards away, depress and hold the power button down until the range reading is displayed near the bottom of the in-view display. Once a range has been acquired, you can release the power button. [. . . ] For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In Europe you may also contact Bushnell at: BUSHNELL Outdoor Products Gmbh European Service Centre MORSESTRASSE 4 D- 50769 KÖLN GERMANY Tél: +49 (0) 221 709 939 3 Fax: +49 (0) 221 709 939 8 This warranty gives you specific legal rights. You may have other rights which vary from country to country. TROUBLE SHOOTING TABLE If unit does not turn on - LCD does not illuminate: · If unit powers down (display goes blank when attempting to power the laser): · If target range cannot be obtained: · NOTE: The last range reading does not need to be cleared before ranging another target. [. . . ]