User manual C-SCOPE CS770XD

[. . . ] Switch the site selector (16) to `inland'. Reset the sensitivity (if necessary) to the point where a tone is just about audible. Start searching using a relaxed motion swinging the search-head from side to side as close to the ground as possible. Press the Retune button (15) every few minutes or whenever the background tone rises to an unacceptable level. You are now searching in `inland audio discrimination mode'. [. . . ] It is good detecting practice to press the retune button every few minutes or whenever you feel that that the detector may have drifted away from its sensitivity setting. Assembly Join the two stem sections (5)(2) together. Wind the search-head lead (9) around the stem as shown in the photograph. Adjust the stem for length according to your height (it's easier on your back if you can stand up straight while detecting) and tighten the twistlock stem adjuster (6). Check that the search-head (7) is parallel to the ground when being swept in an arc and tighten (be careful not to over-tighten) the search-head retaining screw (8). (Keep these parts clean - if they become covered in mud or sand wash and dry these parts at the end of a day's detecting. Don't allow any form of lubricant onto the rubber friction washers. ) Battery Push back the retaining clip and remove the cover (13) of the battery compartment (12). Fit a 9 volt battery (MN1604, PP3 or equivalent). There are guide strips to ensure the battery is fitted the right way round. It should slide in easily to connect with contact strips in the compartment. Remove the battery if the detector is to be stored for more than a few days. Searching Technique: Try out a variety of targets to test the reaction of the audio target analysis system. Iron nail, gold ring, £1 coin, for example. Check the intensity and the pitch of the signal. Note how the detector signal changes and, as you gain experience of this feature, you will become adept at making decisions about whether to dig or not. For starters, if you are in any doubt, it's safer to dig!Sweep the detector head from side to side in a smooth arc. Move forward at each sweep the width of the search-head. [. . . ] Stem and search-head parts should be washed with tap water and dried at the end of a day's detecting. warranty & Service The CS770XD is guaranteed free of manufacturing defects as confirmed in our written warranty document. Contact us if you have any concerns about the operation of your detector. The C. Scope Customer Service Team really know about metal detectors and are always ready with good advice and rapid after-sales-service. [. . . ]