User manual CADILLAC SEVILLE 1999

[. . . ] yellowblue The 1999 Cadillac Seville Owner's Manual 1-1 2-1 3-1 4-1 5-1 6-1 7-1 Seats and Restraint Systems This section tells you how to use your seats and safety belts properly. It also explains the "SIR" system. Features and Controls This section explains how to start and operate your vehicle. Comfort Controls and Audio Systems This section tells you how to adjust the ventilation and comfort controls and how to operate your audio system. Your Driving and the Road Here you'll find helpful information and tips about the road and how to drive under different conditions. Problems on the Road This section tells you what to do if you have a problem while driving, such as a flat tire or overheated engine, etc. Service and Appearance Care Here the manual tells you how to keep your vehicle running properly and looking good. Customer Assistance Information This section tells you how to contact Cadillac for assistance and how to get service and owner publications. It also gives you information on "Reporting Safety Defects" on page 7-10. 8-1 Index Here's an alphabetical listing of almost every subject in this manual. You can use it to quickly find something you want to read. i yellowblue We support voluntary technician certification. GENERAL MOTORS, GM and the GM Emblem, CADILLAC, the CADILLAC Crest & Wreath and the name SEVILLE are registered trademarks of General Motors Corporation. [. . . ] D FRONT SEAT: This setting adjusts the audio to give the front seat occupants the best possible sound qualities. FRONT SEAT can be used at any time for any material. Rear seat passengers in the vehicle may not get the same effect. D AMBIENCE: This setting is used to enhance the stereo effect. D SPACIOUS: This setting is used to make the listening space seem larger. Adjusting the Speakers TONE: Press and release this button until the desired BALANCE or FADE control is found. LEVEL: After selecting the desired BALANCE or FADE control, press the plus (+) or minus (-) symbol on this button to select the desired level. Playing a Cassette Tape With the radio on, insert a cassette tape. The tape will begin playing as soon as it is inserted. When one side of your cassette tape is done playing, auto reverse plays the other side of your cassette tape. Cassette tapes may be loaded with the radio off but they will not start playing until the radio is on. If you want to insert a cassette tape when the ignition is off, first press the eject button. While the tape is playing, use the VOL, TONE, LEVEL and DSP controls just as you do for the radio. Other controls may have different functions when a tape is inserted. The display will show an underlined tape symbol. TAPE PLAY will appear on the display when a tape is playing, with an arrow to indicate which side of the tape is playing. 3-23 yellowblue If an error occurs while trying to play a cassette tape, it could be that: TUNE-SEEK: When this button is pressed, it has two positions. This button works the same, whether it is pressed to the first or second position. Press this button to seek to the next or previous selection on the tape. Your tape must have at least three seconds of silence between each selection for TUNE-SEEK to work. SCAN: Press this button to listen to selections for a few seconds. The tape will go to a selection, stop for a few seconds, then go on to the next selection. Press this button again to stop scanning. [. . . ] 7-11, 7-12 Paint Radio Data Systems (RDS) Program Type (PTY) Selections . 3-26 Radio Personalization with Home and Away Feature . 2-54 Turn Signal Lamp, Bulb Replacement . 6-40 Underseat Bussed Electrical Center . [. . . ]