User manual CAKEWALK SONAR 4

[. . . ] Cakewalk SONAR User's Guide © TM Information in this document is subject to change without notice and does not represent a commitment on the part of Twelve Tone Systems, Inc. The software described in this document is furnished under a license agreement or nondisclosure agreement. The software may be used or copied only in accordance of the terms of the agreement. It is against the law to copy this software on any medium except as specifically allowed in the agreement. [. . . ] Click OK. SONAR applies the specified event filter to the selected data, removing all those events that do not meet the filter criteria. Adding Arpeggio The Arpeggiator command applies an arpeggio to its input and plays it back in real time. You can make it arpeggiate with a swing feel, or straight and staccato or legato, vary its speed and direction, and specify its range. The parameters used to specify the arpeggiator effect are as follows: Parameter/Option. . . Swing (%) Meaning. . . The distortion of timing used to produce a swing feel. A value of 0% indicates a straight rendition; negative and positive values produce distortion of the timing grid. For more information on swing, see "Swing" on page 297. You may specify delay in ticks, in milliseconds, or as a note duration. The smoothness of the notes of the arpeggio. 1 percent plays each notes and releases it instantly. 99 percent plays each note up to the start of the next note. Options are Up, Up (arpeggios go up), Up, Down (arpeggios go up, then down), Down, Down (arpeggios go down), Down, Up (arpeggios go down, then up). The disposition of the notes you play to specify the arpeggio. Unchecked filters out the original notes. Rate Units Legato (%) Path Play thru 329 Specify output range The range over which the arpeggio plays. Checked specifies that the arpeggiator repeats notes at each octave over the entire specified range. Unchecked specifies that the arpeggiator includes only the notes you actually play. The MIDI number of the lowest note of the arpeggio. Checked specifies that the arpeggiator infers the chord from the notes played in the range. It identifies the chord in the Chord recognized box and uses it to play arpeggios for notes outside the range. The MIDI number of the lowest note the arpeggiator uses for chord recognition (0 to 126). The chord the Arpeggiator recognizes and plays. Lowest note Span (Notes) Use chord control Lowest note Span (Notes) Chord recognized To Apply the Arpeggiator to MIDI Data 1. Choose MIDI Effects-Cakewalk FX-Arpeggiator from the Process menu or from the popup menu to open the Arpeggiator dialog box. Set the arpeggiator parameters, as described in the table above. Click OK. SONAR applies the specified arpeggio effect to the selected data. Analyzing Chords The Chord Analyzer command analyzes chords. [. . . ] Cakewalk does not warrant that the Product will be error free, nor that all program errors will be corrected. In addition, Cakewalk makes no warranties if the failure of the Product results from accident, abuse or misapplication. Outside the United States, these remedies are not available without proof of purchase from an authorized international source. All requests for warranty assistance shall be directed to Cakewalk at the following address: Cakewalk 268 Summer st. [. . . ]