User manual CALDWELL THE ROCK BR

[. . . ] Slide the Coarse Adjustment Center-Post (H. ) into its corresponding hole in the Base, aligning the slot in the side of the Post with the tip of the Lock. Tighten the Center-Post Lock sufficiently to secure the Coarse Adjustment Center-Post. Thread the remaining Center-Post Lock into its corresponding hole in the side of the Coarse Center-Post just short of the tip of the Lock protruding into the Fine Adjustment Center-Post hole. [. . . ] Rotate each Adjuster Foot until the points protrude about a half-inch through the bottom of the base legs. Leave the Adjuster Foot Lock Nuts loose. Set the Rock BR on the shooting table or bench with the two front legs (those closest together) toward the intended target. WARNING: Do not lift the Rock BR by the Cradle/Windage Plate assembly. Level the Rock by means of the Adjuster Feet until the bubble is centered in the Level. The Rock BR features two primary means of Elevation Adjustment, and one secondary. Loosen the Coarse Center-Post Lock (lower knob) and lift the rest assembly to a position slightly below the general height desired. Tighten the Coarse Center-Post Lock to secure the rest at this height. For Finer Adjustments, loosen the Fine Center-Post Lock and use the Fine Elevation Adjustment Wheel to raise and lower the rest assembly. Turn to the left to raise the rest assembly or to the right to lower. Tighten the Fine Center-Post Lock to hold this position. Very Fine Adjustments can be made by loosening the rear Adjuster Foot Lock Nut and turning the Adjuster Foot clockwise to raise and counter-clockwise to lower. (Doing this will cause the Bubble Level to no longer show level). Windage Adjustments are made by rotating the Windage Screw Knob clockwise to move to the right and counter-clockwise to move to the left. Coarse changes in windage can also be made by shifting the rear leg of the Base to the left or right. Place the rifle forend between the ears of the front rest Bag so the forend of the stock rests firmly against the Forend Stop. [. . . ] All machined components are stainless steel or aluminum alloy. No lubrication is needed at the contact points between the Cradle Plate and the Windage Plate. For ease of operation, a small amount of grease should be applied to the threads of the Adjuster Feet, Lock Nuts, and the Fine Center-Post and its Elevation Wheel, the mating components of the Base and the Coarse Elevation Center-Post, and on both sides of the Thrust Bearing. [. . . ]