User manual CAMBRIDGE AUDIO INCOGNITO LK10 EU INSTALLATION GUIDE

[. . . ] I. C. P - In-circuit programming socket, used to upgrade keypad software when necessary. 5 Installation notes The LK10 is fitted on the wall by fixing it into a standard UK 47mm depth double-gang electrician’s back-box (pattress). All knock-outs in the back-box should be removed to provide maximum ventilation. Where it is desired to fit a mains lighting switch etc next to a keypad, a barrier-box or two single backboxes must be used (bear in mind it is not preferable to fit the keypad next to a light-switch particularly if the faceplate styles will differ). Only a qualified electrician should attempt such installations. [. . . ] The Incognito LR10 is a sophisticated learning remote which is able to learn the codes of all the source equipment from their own remotes. Once the LR10 itself has been programmed the user can clone all macros and programmed information from the LR10 to the LK10, allowing the keypad to also perform the same operations (IR codes, macros, button names and clock settings). Note: Only the learning buttons highlighted on the remote are cloned to the LK10. Please refer to the LR10’s own manual for full details on how to teach codes into the LR10, advice on macros etc. Once the LR10 is fully programmed/setup, you can clone it into the LK10. To begin cloning, plug the supplied connection cable into the cloning port on the LK10 and LR10, then put the LK10 into Learn mode. Set the LR10 to transmit (the LK1O will default to Receiving mode). On the back of the LR10 press the Edit button 4 times (using a paperclip or similar) to enter Clone mode. ‘REC/TRX’ will appear on both displays. Shift Fav-1 (Set) Menu Title Exit 10 LK10 For the LK10 to receive commands, it must be first put into Learn mode. The LK10 has a series of menus that can be accessed by pressing and holding the Shift/Set button on the front panel. The menu options are continuously scrolled on the LK10 display until you release the Shift/Set button. Follow the next steps to complete the cloning operation: ENGLISH LK10 keypad - Receiving data 1 2 LR10 remote - Transmitting data 1. Press and hold the Set button for five seconds. When ‘LEARN’ is displayed, release the button. ‘READY’ will then be displayed on screen. 4 3 2. Press the is flashing. button on the remote until ‘TRX’ 4. ‘RXING. . ’ will then be displayed, to indicate it is receiving data. 3. Display shows ‘SENDING’. 11 Cloning from the remote control continued After approximately 7 minutes the keypad display should show ‘COMPLETE’ and return to normal operation. If the clone fails the keypad will show ‘ERROR’ or ‘TIMEOUT’. Put the transmitting LR10 remote back into Clone mode and repeat the process. Note: Once the cloning process has been started it must be completed, as it overwrites the software in the receiving LK10 keypad. 12 LK10 Note: You still use your KP10 keypad to control audio functions (volume adjustment, source selection etc). To personalise other settings of the LK10, press and hold the Set button for four seconds to activate the Settings menus (Fig. [. . . ] Any unauthorised repairs will void this warranty. This warranty does not cover products sold AS IS or WITH ALL FAULTS. REPAIRS OR REPLACEMENTS AS PROVIDED UNDER THIS WARRANTY ARE THE EXCLUSIVE REMEDY OF THE CONSUMER. CAMBRIDGE AUDIO SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY IN THIS PRODUCT. [. . . ]