User manual CAMBRIDGE SOUNDWORKS TVWORKS 250

[. . . ] However, this notice is not a guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try one or more of the following measures: · · · Reorient or relocate the receiving antenna. Increase the distance between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. [. . . ] For VCD movies with Dolby Surround-encoded stereo program: You can use the Dolby Pro Logic decoder, by selecting PRO LOGIC DIGITAL IN, to experience 5. 1-channel movie viewing. For VCD movies: You will have Digital 2. 1 channel output. To enhance the experience, enable the Digital Pro Logic by pressing the DOLBY SURROUND button until the DIGITAL IN LED lights up. Using SoftMPEG player or PlayCenter on PC 1. Select the MOVIE mode by pressing the Creative Multi Speaker Surround (CMSS) button until the LED for MOVIE mode lights up. This mode lets you experience the surround sound with 5. 1channel output; all dialog and central sounds will be heard through the center speaker, while music and off-stage sounds are heard through the other four satellites. If you are using PlayCenter to play the VCDs, disable all CMSS effects in your PlayCenter - use only TVWORKS 250 Digital CMSS MOVIE mode. Connect Video Out of the VCD player to Video Input of your television. Connect the Audio Out of the VCD player to the Line In of your TVWORKS 250 Digital decoder amplifier unit. Select the MOVIE mode by pressing the Creative Multi Speaker Surround (CMSS) button until the LED for MOVIE mode lights up. You can experience surround sound instead of mono/stereo sound; all dialog and central sounds will be heard through the center speaker, while music and off-stage sounds are heard through the other four satellites. There are many mounting possibilities. After you have positioned the rear satellites, use the test sound to make sure each speaker can be heard clearly. The subwoofer's optimum position is on the floor against the wall under the computer desk. The nearer the subwoofer is to the corner of the room, the stronger its maximum bass output will be. We strongly recommend placing the subwoofer on the floor (see Diagram J). Leave at least 8 cm (3 inches) of space between the subwoofer face and a wall. Small objects in front of, but not touching the subwoofer (table legs, for instance) will have no effect on its sound. If you have no available floor space, the subwoofer can be placed on a shelf, desktop or other sites, but its maximum output will be reduced. The subwoofer is not magnetically shielded, so position it at least 18 inches away from a computer monitor. You may substitute a powered subwoofer for the subwoofer that comes with the TVWORKS 250 Digital. Connect its line level input (typically an RCA jack) to the dedicated subwoofer output on the back of the Decoder Amplifier, using a shielded audio cable with RCA plugs on each end. Refer to the powered subwoofer's User Manual for adjustment procedures. Playing DVD Movies: Using PC-DVD player on PC 1. [. . . ] Master: Adjusts the volume of the entire system. Center, Subwoofer and Surround: These controls adjust the level of the indicated channels. Their output level should be balanced with the fixed output level of the Left and Right front speakers. Top Row 4. Creative Multi Speaker Surround: CMSS processes analog program material. [. . . ]