User manual CAME A3106

[. . . ] If this is the case, it is necessary to modify the pillar so that this measurement cor-responds; - the electrical wiring path according to the position of the control and safety instruments; - presence of a mechanical gate stop (securely anchored to the ground) in the closed position in order to prevent the gate and the reduction gear from moving beyond the correct close position. Attach the fixing plate and the rear bracket (fig. [. . . ] This therefore increases the peripheral speed and reduces the thrust exerted by the motor on the gate. With the gate closed, attach the fixing plate with the front bracket to the gate wing. The anchor plate must be horizontally aligned with the rear bracket and measurement E must be observed. Remove thje two screws which hold the casing in position and remove the rod. Remove thje two screws which hold the rod in position and remove the rod. Install the gear motor on the two brackets Montar el motorreductor en los dos soportes. Slide the microswitch unit along the microswitch-support rod until it is inserted by contact on the microswitch unit actuation runner. Fix the microswitch unit by tightening the respective screws. -8- A5000 A5006 A5024 Chiave Key Llave Sportellino Access door Portillo CA ME 180 Per sbloccare Releasing the unit l'operazione di sblocco va effettuata a perform this step with the motor stopped: motore fermo: 1) raise the access door; 1) sollevare lo sportellino; 2) insert and turn the key. - Attach the rear bracket together with a supplementary bracket and fasten both to the column. - Open the gate (maximum 90°) and measure "E" (see Tab 4), then fasten the front bracket to the gate. 2 N M F FA RC R RA Morsettiera motore Motor terminal block Caja de bornes para el motor Massa Ground Tierra U V W Morsettiera quadro comando Control panel terminal block Caja de bornes cuadro de mando U X -10- V Y W W Motore - Motor - Moteur 1 Motore - Motor - Moteur 2 N1 N2 M1 M2 F F FA1 FA1 RC1 RC2 R1 R2 RA1 RA2 MANUTENZIONE PERIODICA / PERIODIC MAINTENANCE / MANTENIMIENTO PERIÓDICO -11- ITALIANO - Lubrificare la vite senza fine e i perni di rotazione; - Controllare le viti di fissaggio; - Verificare l'integrita' dei cavi di collegamento. [. . . ] Hereby declare, under their own respons ibility, that the product/s called . A3000 • A3006 • A3100 • A3106 • A3024 • A3124 A5000 • A5006 • A5100 • A5106 • A5024 • A5124 D001 • H3000 • LOCK81 • LOCK82 … comply with the Italian National Legal Provisions that transpose the following Community Directives (where specifically applicable): MACHINERY DIRECTIVE 98/37/CE LOW VOLTAGE DIRECTIVE 73/23/EEC - 93/68/EEC LECTROMAGNETIC COMPATIBILITY DIRECTIVE 89/336/EEC - 92/31/EEC R&TTE DIRECTIVE 1999/5/CE IMPORTANT CAUTION! [. . . ]