Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CAME AT02. We hope that this CAME AT02 user guide will be useful to you.
Lastmanuals help download the user guide CAME AT02.
Detailed instructions for use are in the User's Guide.
[. . . ] The overall power of the 24V accessories must be not exceed 5W. The control panel must be supplied (voltage 230V a. [. . . ] The control panel must be supplied (voltage 230V a. The controls operate at a low voltage (24V) protected by a 630mA fuse; the same low voltage can also used to supply the photocells, if fitted. SAFETY FUNCTIONS
Photocells can be connected to obtain: - Re-opening during closure (2-C1), if the photocells identify an obstacle while the gate is closing, they will reverse the direction of movement until the gate is completely open; - Total stop (1-2), shutdown of gate movement without automatic closing; a pushbutton or radio remote control must be actuated to resume movement. FUNCTIONS AVAILABLE
- "Human presence" control: the gate is in motion only whilst the command button is pressed (escludes the radio control); - Automatic closing: closure begins after a pre-established time span (which can be set), after the gate's complete aperture; it is nonetheless subject to the use of possible safety accessories and it is discontinued after a "stop" command has been given or when power is unavailable;
OTHER ACCESORIES WHICH CAN BE CONNECTED
- Courtesy light (E1-E3): a light that comes on each time the opening command is activated and which stays on for 130 seconds (i. - To prevent improper operation, do not install receivers at distances of less than 4-5 m (between one receiver and the another). If using radio frequency board AF43S, position the jumper according to the transmitter type (fig. 10), whereas for the AF43SM board, carry out the instructions on the relevant instruction sheet; C)Code the transmitter (page 9); D)Supply power to the control panel; E) Memorize the code on the board (fig. 10) in this way: -press down and hold the "PROG" key on the base board (the signal LED will flash); -send the code with a button on the transmitter. The LED will remain lit to indicate that the data has been saved place. : if you subsequently wish to change the code, repeat the sequence described above. [. . . ] The LED will remain lit to indicate that the data has been saved place. : if you subsequently wish to change the code, repeat the sequence described above. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CAME AT02
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CAME AT02 will begin.
