User manual CAME ATI KIT FOR SINGLE GATE

[. . . ] Power to accessories Stop Photocells (re-opening during closing) Contact for central sensor (used only when interface system is installed) Contact for outer sensor (can be disabled) Contact for inner sensor Contact for "step-by-step" operation (manual button)* MF9011 - MF9111 AP/PARZ TCA V. - Contact 1-2 and 2-C1 are normally closed (N. To use these functions, replace the bridge connections with the relative devices. [. . . ] If this occurs, proceed as follows: No objects are present along the path taken by the door wings as they move; -Disconnect the mains power All mounting hardware has been properly tightened; - Make sure dip switch 1 is set to OFF The sensors are correctly aligned and are not blocked; - Reverse connections M-N on the terminal board for the motor, which The desired functions have been correctly selected on the dip switches; is located in the electrical cabinet (on the right) The trimmers have been set to their midpoints. - Begin another start-up/calibration procedure starting from point 1. 8 will light up - The system will execute an closing and opening cycle at reduced speed and will stop at the maximum open position (1) at the end of the cycle - LEDs no. Make sure that function switch MA7041 (if installed) has been set to the “open” position (with the LEDs lit in sequence) 5. Enter an "open" command on 2-R1/2-R2 or by pressing the open key - the automation will position itself at the closing point 6. Send an opening signal - the automation will perform a complete manoeuvre 7. Adjust the movement of the doors using the door trimmers 8. Locking with doors closed and open The unit locks both when open and closed (when positioned correctly (1)), and is released electrically by each open and close command. The electric lock is unlocked when the first “open” command is given at initial start-up or after a power failure, or when “door open” is selected on MA7041. The lock is locked when “door closed” or "output only" is selected on MA7041. ENGLISH MA7032 - Battery-powered emergency system This emergency system opens the door in case of power failure. 2Ah) batteries as well as a circuit card that keeps the batteries charged and distributes power to the automation system. By using dip switches 9 and 10 (10-way module), the emergency system can be programmed to operate in the following ways when the power fails: Note: Note When functioning is interlocked (see p. 18), the following functions are selected equally for both automations. [. . . ] This procedure consists in the opening or closing of the doors (depending on the settings of dip switches 9 and 10). For the interlock system, the safety procedure (signalled by a continual flashing of LED No. 2 on the MASTER panel) causes the doors to open on both the automatic system. [. . . ]