User manual CAME BK800

[. . . ] - The wheel guide must be firmly attached to the ground, completely exposed, and without any irregular sections which might hinder the movement of the gate. [. . . ] Construct a cement foundation that is large enough to accomodate the gear motor (it is a good idea to protrude 50 mm. When pouring the foundation, embed the gear motor anchor plate and the relative clamps in the cement. The anchor bolts should be embedded in the concrete in the positions indicated; the drive unit is then attached to this bots. The anchor plate must be perfectly level and absolutly clean; the bolts threads must be completly exposed. If the rack is already attached, proceed directly to the adjustment of the rack/pinion coupling. When the necessary adjustment have been completed, fasten the unit in position by tightening the two anchor bolts. - Position the limit-switch tabs (whose positions determine the limits of gate travel) on the rack. Note: do not allow the gate to strike the mechanical stops in the open or closed positions. [. . . ] DOSSON DI CASIER (TREVISO) (+39) 0422 4940 (+39) 0422 4941 NC COM M Motore monofase 230V 230V single-phase motor Moteur monophasé 230V Einphasiger Motor 230V Motor monofásico de 230V All data checked with the maximum care. [. . . ]