User manual CAME BKE1810

[. . . ] To resume the movement, use the pushbutton or the radio control; - Safety test function. The control unit will now check the safety system every time an opening or closing command is given (see p. The electric panel includes an amperometric sensor for the motors which is triggered when an obstacle blocks movement during ENGLISH opening or closing. [. . . ] This inverts the movement direction when the motor is in gear, whereas the motor blocks if it is slowing down. The sensitivity of the device is adjustable by using the trimmers 6-7-8 (page 12). The transformers are equipped with a guard, which in case of thermal overload will keep the door open. They are closed again only after the temperature falls below the emergency threshold. Accessories which can be connected to this unit - “Door open” signal light; - Flashing signal light when gate is in motion; - Cycle lamp; - Electric lock; - LB18 circuit card for emergency battery, which is automatically connected in case of power failure; battery is recharged when line power is restored - Radiofrequency AF board (see table pag. The automatic closing timer is automatically activated at the end of the opening cycle. The preset, adjustable automatic closing time is automatically interrupted by the activation of any safety system, and is deactivated after a STOP command or in case of power failure; - Obstacle detection: When the motor is stopped (door is closed, open or half-open after an emergency stop command), the -4- transmitter and the control pushbutton will be deactivated if an obstacle is detected by one of the safety devices (for example, the photocells); - Hammer movement: This feature makes it easy for the lock to release (the door wings momentarily press against the closure stops when the open command is given, which facilitates release of the electric lock); - Cycle lamp The lamp which lights the lamp. It allows the gearcase to check the efficiency of the safety devices (photoelectric cells) after each command to open or close. Any anomaly of the photoelectric cells is identified with a flash of the LED on the control panel; therefore all functions of the remote control and buttons are cancelled. electrical connection for safety-test functioning. The transmitters and the receivers of the photoelectric cells must be connected as illustrated in figs. IMPORTANT: When the safety test function is performed, check that there are no jumpers between contacts 2-C3, 2-C1 and, if not being used, exclude them using dip switches 8 and 10. 92 MHz (TOP and TAM series), position the jumper connection on circuit card AF43S as shown on the sheet. B The first encoding operation must be carried out whilst keeping the jumpers positioned for channels 1 and 2 as per fig. [. . . ] B The first encoding operation must be carried out whilst keeping the jumpers positioned for channels 1 and 2 as per fig. B for any subsequent settings on different channels. Plantear el código en el dip-switch C y el canal en D (P1=CH1 y P2=CH2, planteamiento por defecto) D P1 CH1 CH2 CH3 CH4 C P2 CH1 CH2 CH3 CH4 T434M - T314M P1=CH1 P2=CH2 P3=CH3 P4=CH4 T432S / T432SA / T434MA vedi istruzioni su confezione see instructions on pack voir instructions sur l’emballage Siehe Anleitungen auf der Packung. [. . . ]