User manual CAME BN1

[. . . ] The total power consumption of 24V acces- Warning!If an obstacle is detected two times sories (which are protected by a 3. 15A-F in a row during the closing phase (and when the Automatic Closing function is on), the fuse) must not exceed 40 W. [. . . ] The ADT card (sup3) Block all functions of the control panel. Plied in the control panel box) manages these slower movements, also decreasing the To reactivate the operator, send a “close comamount of connection cables (see mand” by pushing the buttons connected on 2-3, 2-3P and 2-7 (only the button). - The transformers are equipped with a guard that will keep the doors open in case of therPhotocells can be connected to obtain: mal overload. - Re-opening during the closing cycle (2-C1), They are closed again only after the temperif the photocells identify an obstacle while ature falls below the overload threshold. The gate is closing, they will reverse the direction of movement until the gate is completely open; - Partial stop, shutdown of moving gate, with activation of an automatic closing cycle (2-C3); Safety -4- Description of control panel - Hammer movement. This feature makes it Accessories which can be connected to easy for the lock to release (the door wings this unit momentarily press against the closure stops - “Gate open” signal light (10-5); when the open command is given, which fa- Cycle lamp to light the passage area: it cilitates release of the electric lock); remains on from the moment the doors begin - "Operator present" function. Gate operates to open until they are fully closed (including only when the pushbutton is held down (the the automatic closing time). If automatic radio remote control system is deactivated); closing is not activated, the lamp remains on - Type of command: only during movement. - «open-stop-close-stop» for pushbutton - Movement flashing lamp with pre-flashing and radio transmitter; option (dip 4 function selector); - «open-close-reverse» for pushbutton - Electric lock; and radio transmitter; - LB18 circuit card for battery operation, - «open only» for radio transmitter. A - WITH LB18 board, leave just one jumper on B-D and BN1 + EMEGA + LB18 + E881 connect the board as shown in the relative documentation. B - WITHOUT LB18 board, change jumper C-D into B-D. BN1 The ADT card is fastened to the gear motor terminal board as illustrated, and connected to the control panel only with terminals M, N and R. NOTE: RA terminal is not active with FERNI and EMEGA. BN1 But after connection to the gear motor's outlet cables, the ADT card and terminal board can be left inside the control panel or in a similar sealed box with FROG gear motors. 3) with the "adjust microswitches" procedures shown in the gearmotor's manual… …take the template - which is supplied with the control panel - and hold it up against one of the two mechanical stops as shown in fig. 1 (adjustment is to be made either on the closing endstop or opening endstop). Activate the gate - either using a command button or the remote control - and turn the OP TIME trimmer clockwise until the gate leaf inverts its direction just as it touches the obstacle/template. Then turn the template from its short side (fig. [. . . ] 2) and turn the OP TIME trimmer counterclockwise until the gate leaf stops against the obstable/template. MAX faston rallentamento slowdown speed faston faston ralentissement Faston Laufverlangsamung faston ralentamiento ENGLISH To adjust the operating and slowdown speeds, move the faston connectors to the indicated connectors. 92 MHz (TOP and TAM series), position the jumper connection on circuit card AF43S as shown on the sheet. [. . . ]