User manual CAME C1-C2H

[. . . ] ) at terminal blocks L1-L2 and the inlet is protected with two 5A fuses. 15A fuse protects the low voltage command devices. [. . . ] The accessories’ total wattage (24V) must not exceed 20W. (E1-W): distancia); - Electric lock (11-ES); - Radiofrequency «AF» board (see table pag. The automatic closing timer is automatically activated at the end of the opening cycle. The preset, adjustable automatic closing time is automatically interrupted by the activation of any safety system, and is deactivated after a STOP command or in case of power failure; - "Operator present" function: Gate operates only when the pushbutton is held down (the radio remote control system is deactivated); ADJUSTMENTS - Trimmer TL = Adjustment of operating time; - Trimmer TCA = Adjustment of automatic closing. Disconnect the unit from the main power lines before carrying out any operation inside the unit. 92 MHz (TOP and TAM series), position the jumper connection on circuit card AF43S as shown on the sheet. 1 2 1 2 LED intermittente flashing LED LED intermitente LED acceso Lit LED LED encendido -7- ITALIANO ENGLISH -Keep the PROG key pressed on the base card (the signal LED will flash), and with a key on the transmitter the code is sent, the LED will remain lit to signal the successful saving of the code (figure 1). MANUFACTURER’S DECLARATION As per Enclosure II B of Machinery Directive 98/37/CE Enclosed with the technical documentation (the original copy of the Declaration is available on request) The representatives of CAME Cancelli Automatici S. It Date of the present declaration 07/12/2001 Also, they furthermore represent and warrant that the product/s that are the subject of the present Declaration are manufactured in the respect of the following main harmonized provisions: EN 292 PART 1 AND 2 EN 12453 EN 12445 EN 60335 - 1 EN 60204 - 1 EN 50081 - 1 AND 2 EN 50082 - 1 AND 2 MACHINERY SAFETY. Hereby declare, under their own respons ibility, that the product/s called . [. . . ] It Date of the present declaration 07/12/2001 Also, they furthermore represent and warrant that the product/s that are the subject of the present Declaration are manufactured in the respect of the following main harmonized provisions: EN 292 PART 1 AND 2 EN 12453 EN 12445 EN 60335 - 1 EN 60204 - 1 EN 50081 - 1 AND 2 EN 50082 - 1 AND 2 MACHINERY SAFETY. Hereby declare, under their own respons ibility, that the product/s called . [. . . ]