User manual CAME C1-P

[. . . ] ) at terminal blocks L1L2 and the inlet is protected with two 5A fuses. A 1A fuse protects the low voltage command devices. [. . . ] A 1A fuse protects the low voltage command devices. The accessories’ total wattage (24V) must not exceed 20W. SAFETY Photocells can be connected to obtain: - Re-opening during closure (2-C1), if the photocells identify an obstacle while the gate is closing, they will reverse the direction of movement until the gate is completely open; - Total stop (1-2), shutdown of gate movement without automatic closing; a pushbutton or radio remote control must be actuated to resume movement). The automatic closing timer is automatically activated at the end of the opening cycle. The preset, adjustable automatic closing time is automatically interrupted by the activation of any safety system, and is deactivated after a STOP command or in case of power failure; - "Operator present" function: Gate operates only when the pushbutton is held down (the radio remote control system is deactivated); ENGLISH • ADJUSTMENTS ITALIANO REGOLAZIONI - Trimer TL = Tempo lavoro; - Trimer TR2M =Ritardo chiusura del 2° motore (M2); - Trimer TCA = Tempo chiusura automatica. -Keep the “PROG” key pressed on the base card (the signal LED will flash), and with a key on the transmitter the code is sent, the LED will remain lit to signal the successful saving of the code (figure 1). MANUFACTURER’S DECLARATION As per Enclosure II B of Machinery Directive 98/37/CE Enclosed with the technical documentation (the original copy of the Declaration is available on request) The representatives of CAME Cancelli Automatici S. It Date of the present declaration 07/12/2001 Also, they furthermore represent and warrant that the product/s that are the subject of the present Declaration are manufactured in the respect of the following main harmonized provisions: EN 292 PART 1 AND 2 EN 12453 EN 12445 EN 60335 - 1 EN 60204 - 1 EN 50081 - 1 AND 2 EN 50082 - 1 AND 2 MACHINERY SAFETY. Hereby declare, under their own respons ibility, that the product/s called . It is forbidden to market/use product/s that are the subject of this declaration before completing and/or incorporating them in total compliance with the provisions of Machinery Directive 98/ 37/CE TECHNICAL MANAGER MANAGING DIRECTOR Signatures of the Representatives Mr. [. . . ] Hereby declare, under their own respons ibility, that the product/s called . It is forbidden to market/use product/s that are the subject of this declaration before completing and/or incorporating them in total compliance with the provisions of Machinery Directive 98/ 37/CE TECHNICAL MANAGER MANAGING DIRECTOR Signatures of the Representatives Mr. [. . . ]