Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CAME CAT 15. We hope that this CAME CAT 15 user guide will be useful to you.
Lastmanuals help download the user guide CAME CAT 15.
Detailed instructions for use are in the User's Guide.
[. . . ] - the motor is mounted on a base-guide in galvanised sheet metal. - plastic cover with refractive etement for illumination of the area nearby. Recommended when the distance between the springbar and the upper edge of the door is between 30 and 60 cm. [. . . ] Fit the chain to the pinion and insert the guides into the anchor slots on the gear motor. - Fin bracket “A” to the chain tensioner connector and turn the nut to adjust the tension of the chain. Bolt or rivet bracket “A “ in the Gen tre of the door frame (recommended position) or to the wall itself, about 10-20 mm above the highest position reached by the door during movement. Remove the cover and lift: - the cable fairlead supplied with the unit - the “B” brackets to the unit and then to the ceiling using the angle brackets to be fixed with some screws or bolts. - Fasten bracket “C” to the upper cross-member of the door using the rivets supplied with the unit. If it is necessary to replace the standard bracket “C” and the standard arm with the V201 kit (for overhead doors) or V122 kit (for sectional doors), refer to paragraph “OPTIONAL ACCESSORIES “ on page 4. ENGLISH
TECHNICAL DESCRIPTION ZL54 MOTHERBOARD
Accessories which can be connected to this unit - LB54 board, used to power the automation system using battery power in case of a power failure. When an obstacle is encountered, the amperometric locking device intervenes as follows: a) if in the aperture phase, the door wing stops; b) if in the closure phase, the movement of the bar is reversed. : In situation (b), if an obstacle is detected three times, the door wing stops during aperture, and automatic closure is disactivated. Use the keyboard or the radio transmitter to resume movement of the bar. ) for «re-aperture during closure» Contact (N. : To reduce motor speed, see the example depicted to the side. When connecting the photocells (TX and RX), observe the correct polarities. 92 MHz (TOP and TAM series), position the jumper connection on circuit card AF43S as shown on the sheet. [. . . ] Press the "open-close" button again until the door is about 200 mm. From the fully-closed position, then press the "stop" button to stop the door in this position. Turn the red camme until the microswitch trips and turn trimmer T. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CAME CAT 15
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CAME CAT 15 will begin.
