User manual CAME CAT-X24

[. . . ] : used thermosetting polyester-resin paint on all painted surfaces. To insure easy installation and conformance with current safety norms, we raccomend installation of CAME safety and control accessories. [. . . ] 3) Place the unit on the anchor plate and tighten the anchor bolts. 4) The exact length of chain required is calculated by subtracting 500 mm. From the net distance between the pillars. 5) Attach one end of the barrier chain to the coupling fitted to the service chain. 6) With the unit still in the open position, attach the other end of the chain (use the chain release) to the fixed chain mount on CAT 1. 7) Connect the power cables to the terminal board on the control panel. All operating tests must be carried out after installation of the unit and with the barrier chain in position. This is a light that indicates the barrier open position and turns off when the chain activates the closing end-stop (terminals 10-5); - LB35 board, used to power the automation system using battery power in case of a power failure. When the power supply is restored, the batteries are recharged automatically (refer to instruction sheet); Adjustments - Sensitivity of amperometric safety system: min. GB Note: when an obstacle is encountered, the amperometric locking device intervenes as follows: a) if in the aperture phase, the chain stops; b) if in the closure phase, the movement of the bar is reversed. : In situation (b), if an obstacle is detected three times, the chain stops during aperture, and automatic closure is disactivated. Use the keyboard or the radio transmitter to resume movement of the bar. 15A line fuse 2A accessories fuse "Function selection" dip-switch Radiofrequency board socket TCA trimmer: automatic closing time adjustment SENS trimmer: amperometric sensitivity adjustment Button for memorizing code numbers Radio code / automatic closing signal LED Connectors for power supply motor Connectors for connection to battery charger (LB35) Jumper for selection of type of control for button in 2-7 GB 12 7 4 F 1 2 3 4 5 6 7 8 9 10 11 Plaque à bornes de connexion Fusibles de ligne 3. When connecting the photocells (TX and RX), observe the correct polarities. [. . . ] B for any subsequent settings on different channels. Plantear sólo el código vedi istruzioni su confezione see instructions on pack voir instructions sur l'emballage Siehe Anleitungen auf der Packung. [. . . ]