User manual CAME CGE

[. . . ] - plastic cover with refractive etement for illumination of the area nearby. Recommended when the distance between the spring-bar and the upper edge of the door is between 30 and 60 cm. - V201: adaptor arm for overhead doors C with counterweight balancing (page 5). - This lever should be fitted when the distance between the spring-bar and the upper edge of the door is between 30 and 60 cm. [. . . ] PER ULTERIORI INDICAZIONI , - The extension guide should be used if the height of the door is between 2. Connect the three guides sections using the two junction brackets. If the height of the door is over the operating limits at page 2, use the V203 extension kit, adding the supplementy guide and junction bracket. Connect the 2 metre chain extension to the original chain, using the chain coupling link. - Insert the chain into the guides, positioning the chain coupling and the sliding block at approximately the midway point of the guides. The chain tensioner coupling should be positioned as shown in the figure. Fit the chain to the pinion and insert the guides into the anchor slots on the gear motor. - Fin bracket “A” to the chain tensioner connector and turn the nut to adjust the tension of the chain. Bolt or rivet bracket “A “ in the Gen tre of the door frame (recommended position) or to the wall itself, about 10-20 mm above the highest position reached by the door during movement. Remove the cover and lift: - the cable fairlead supplied with the unit - the “B” brackets to the unit and then to the ceiling using the angle brackets to be fixed with some screws or bolts. ) for «re-aperture during closure» Contact (N. : To reduce motor speed, see the example depicted to the side. When connecting the photocells (TX and RX), observe the correct polarities. 92 MHz (TOP and TAM series), position the jumper connection on circuit card AF43S as shown on the sheet. B The first encoding operation must be carried out whilst keeping the jumpers positioned for channels 1 and 2 as per fig. B for any subsequent settings on different channels. Plantear sólo el código 9 10 1 2 3 4 5 6 7 8 C vedi istruzioni su confezione see instructions on pack voir instructions sur l'emballage Siehe Anleitungen auf der Packung. -Keep the CH1 key pressed on the base card (the signal LED will flash), and with a key on the transmitter the code is sent, the LED will remain lit to signal the successful saving of the code (figure 1). RALLENTAMENTO IN CHIUSURA: APERTURE: press the "open-close" button until the door moves to the desired fully-open position. Rotate the withe cam until the microswitch trips and block it. [. . . ] Rotate the withe cam until the microswitch trips and block it. SOFT-STOP BEIM press the "open-close" button again until the door is about 200 mm. Battuta in chiusura Turn the red camme until bloccandola con il the microswitch trips and pulsante "stop", turn trimmer T. Ruotare la camma completely to the "+" rossa fino all'inserisymbol. [. . . ]