User manual CAME CLOK

[. . . ] To insure easy installation and conformance with current safety, norms, we raccomend installation of CAME safety and control accessories. B) for A-B-type overhead doors (see ref. 2) and consequently fasten the bracket on high with adequate screws or rivets. [. . . ] Safety Photocells can be connected to obtain: - Re-opening during the closing cycle (2-C1), the photocells on detecting an obstacle while closing the door, cause the movement direction to be reversed until opening is complete; - Total stop (1-2), stop of the garage-type door with the exclusion of the automatic closing cycle. To resume the movement, use the pushbutton or the radio control; - Photocell function test. The control unit will now check the safety system every time an opening or closing command is given (see pag. - Amperometric safety device: see NOTE, pag. 13 Other functions - Automatic closing. The automatic closing timer is automatically activated at the end of the opening cycle. The preset, adjustable automatic closing time is automatically interrupted by the activation of any safety system, and is deactivated after a STOP command or in case of power failure; - Obstacle detection. When the motor is stopped (gate is closed, open or half-open after an emergency stop command), the transmitter and the control pushbutton will be deactivated if an obstacle is detected by one of the safety devices (for example, the photocells); - "Operator present" function. Gate operates only when the pushbutton is held down (the radio remote control system is deactivated); - Pre-flashing. ) contacts and buttons not used should be disconnected with a dipswitch or short-circuited. 2 FUSIBILE 200mA + 10 2 TX C NC TX TX 2 + - - «DIR» 10 11 E E3 TS S 1 2 3 5 7 C1 ENGLISH FRANÇAIS The control unit will now check the safety system (photocells) every time an opening or closing command is given. If a photocell malfunctions, a LED will flash on the control panel, and the radio transmitter and the control pushbutton will be deactivated. electrical connections required for safety test function. Photocell series DOC, lamps and sensors must be connected as follows: - connect the photocell sensor across terminals TS-10. Connect the photocell lamp across terminals 10-11 (see FIG. For DIR series photocells, the connections should be made as follows: -terminal 2 of the photocell transmitter connected to terminal TS of the ZL55E board; -terminal 10-2 of the receiver connected to terminals 10-2 of the ZL55E board; -the photocells should be connected together using terminals TX (see FIG. 2) - move dip switch 9 to ON, which will activate the test function. Press the “CHIUDE” key and allow the garage door to reach the closing ledge. [. . . ] The LED indicator will indicate the irregularity by flashing slowly and continuously. In this case it is necessary to disconnect power supply from the control panel and then reconnect it. The AF board should ALWAYS be inserted when the power is off because the motherboard only recognises it when it is powered. [. . . ]