User manual CAME CORSA 1

[. . . ] B) for A-B-type overhead doors (see ref. 2) and consequently fasten the bracket on high with adequate screws or rivets. : for counterweighted overhead doors, partial entry, it is necessary to use the adapter arm V201 (read the technical documentation provided with the accessory). - Sollevare e fissare la gui- Soulever, fixer et niveler - Prepare the chase for da di trasmissione al soffitla guide de transmission an electric wiring. [. . . ] - Sollevare e fissare la gui- Soulever, fixer et niveler - Prepare the chase for da di trasmissione al soffitla guide de transmission an electric wiring. - Raise and set the guide horizontally to establish the distance from the ceiling; then fasten the angle sections or fastening brackets provided (cutting off any excess part) to the rail’s back terminal. The transmission guide has three ø7 holes for further fastening should it prove necessary to reinforce the unit. 30˚ 9 INSTALLAZIONE DEL MOTORIDUTTORE GEARMOTOR INSTALLATION INSTALLATION DU MOTORÉDUCTEUR INSTALLATION DES GETRIEBEMOTORS INSTALACIÓN DEL MOTORREDUCTOR - Togliere il coperchio del - Remove the automation contenitore automazione, container cover by unagendo sulla vite ø3, 9x13; screwing the ø3. - Turn the handle as illustrated; the rehooking of the release will take place automatically at the first manoeuvre, re-setting the handle in the original position. - If there is a V121 cable release device (read the technical documentation accompanying the accessory for assembly instructions), turn the handle as illustrated to lock and the gearmotor. TECHNICAL DESCRIPTION ZL55 CONTROL PANEL ENGLISH The card is powered with a 230V (AC) power outlet and its input - Type of command: is protected with a 1. Control systems are powered - «open-stop-close-stop» for pushbutton and radio transmitter; by low voltage and protected by a 315mA fuse. The total power - «open-close» for pushbutton and radio transmitter; consumption of 24V accessories (which are protected by a 3. accessories connected - Courtesy Light (24V-25W). ) contacts and buttons not used should be disconnected with a dipswitch or short-circuited. During opening there is only one end-stop mode. While closing, you can choose the stop or slowing function. Position the dip 2 to ON during any adjustment operations. Opening limit switch adjustment - Press and keep pressed the button "AP/ CH". When the overhead door is fully open, press the button again and release it. Turn the white cam until the opening end-stop microswitch is inserted and secure it with a screw. Press and keep pressed Premere/lasciare il tasto the button "AP/CH". "AP/CH", quando la porta When the door reaches arriva in battuta di its closing limit switch, chiusura, ripremere/ rila- press and release the sciare il tasto. Turn the red cam until the Ruotare la camma rossa closing end-stop microfino ad inserire il micro- switch is inserted and interruttore di finecorsa secure it with a screw. [. . . ] "AP/CH", quando la porta When the door reaches arriva in battuta di its closing limit switch, chiusura, ripremere/ rila- press and release the sciare il tasto. Turn the red cam until the Ruotare la camma rossa closing end-stop microfino ad inserire il micro- switch is inserted and interruttore di finecorsa secure it with a screw. With the door either open, position the mechanical end-stop in the transmission guide on the sliding pad and fix it with the screws. Grammed and switched dip 6 to OFF, use the "AP/CH" key to check proper gate opening and closing. [. . . ]