User manual CAME DB-LN

[. . . ] 6 Complete installation by mounting the upper cover with its OR gasket. The automatic closing timer is automatically activated at the end of the opening cycle. The preset, adjustable automatic closing time is automatically interrupted by the activation of any safety system, and is deactivated after a STOP command or in case of power failure; - Obstacle presence detection: When the motor is stopped (gate is closed, open or half-open after an emergency stop command), the transmitter and the control pushbutton will be deactivated if an obstacle is detected by one of the safety devices (for example, the photocells); - Hammer movement. [. . . ] At every opening command, the wings press the closing stop-ledge for a second, thus facilitating the release operation of the electric lock connected to terminals 2-S. It is only active if the wings are closed and at the end of the work time or at the 1st manoeuvre after the system has been powered; - "Operator present" function: Gate operates only when the pushbutton is held down (the radio remote control system is deactivated); - Partial opening, second motor door opening, adjusted with TR2M trimmer; it is activated by collecting to the terminals 2-3P; - Pre-flashing for 5 seconds, while the door is opening and closing; - Type of command: -open-stop-close-stop for pushbutton and radio transmitter; -open-close-reverse for pushbutton and radio transmitter; -open only for radio transmitter. Adjustments - Automatic closure time; - Partial opening time and delay in closing of the M2 motor; - Operating time. Description The ZL150 control panel is suitable for controlling automatic systems for the FLEX series swing gates powered by 24V d. ABS case, which has an IP54 protection level, with air recycling inlet. ) at terminal blocks L1-L2 and the inlet is protected with 1, 6A fuse. The command devices are low voltage and protected by a 1. 11) 10 Radiofrequency board socket 11 5A motor/electric lock fuse 1 2 3 4 5 6 7 8 Plaque à bornes de connexion Fusible de ligne 1. ) Power supply for control unit - 230V (a. ) for re-opening during closing Contact (N. ) for re-closing during opening Contact (N. DROCOMANDO 1 2 3 4 5 6 7 8 9 10 L150 The AF board should ALWAYS be inserted when the power is off. B The first encoding operation must be carried out whilst keeping the J jumpers positioned for channels 1 and 2 as per fig. B for any subsequent settings on different channels. [. . . ] B for any subsequent settings on different channels. Plantear sólo el código vedi istruzioni su confezione see instructions on pack voir instructions sur l'emballage Siehe Anleitungen auf der Packung. Keep the CH1 key pressed on the base card (the signal LED will flash), and with a key on the transmitter the code is sent, the LED will remain lit to signal the successful saving of the code (figure 1). [. . . ]