User manual CAME DF15

[. . . ] Fasten the extensions to the centre of the gatewing. Note: when the motor is laterally installed, superimpose and mount the two anchor bracket/extensions directly onto the vertical stanchion of the gatewing. - Install the motor on the motor base/door. [. . . ] Use the nut, washer and bolt supplied with the unit to secure the tube and the angle brackets. Fit the tube externally, as close as possible to the door arm, and fasten with screw or by welding (see fig. - Fit the square transmission shafts to the motor so that they protrude by 35 mm. Anchor the transmission shafts by tightening the screws on the motor drive shaft (see fig. Lubricate the bushings and insert them into the tran-smission system. Cut the tube so that it is 10 mm shorter than the distances L1 and L2 (i. The distance between the face of the bushing and the edge of the motor drive shaft). Lubricate the arm and insert into the tube. The control panel is powered across terminal L1 and L2, and is protected by a 5A fuse on the main power line. Control systems are powered by low voltage and protected with by a 1. The total power consumption of 24V accessories must not exceed 20W. equipped with a 4 position torque limiter. This system is not subject to wear and tear, is not sensitive to changes of temperature and does notrequire any maintenance. Safety Photocells can be connected to obtain: - Re-opening during the closing cycle, the photocells on detecting an obstacle while closing the door, cause the movement direction to be reversed until opening is complete (2-C1); - Total stop, shutdown of door movement without automatic closing; a pushbutton or radio remote control must be actuated to resume movement (1-2); 11 FRANÇAIS DESCRIPTION TECHNIQUE ARMOIRE DE COMMANDE ZEXOA les bouton-poussoir ou sur la radiocommande (1-2); Autres fonctions - Fermeture automatique. Contatto radio e/o pulsante apre-chiude Contact radio and/or pushbutton controlled for open-close Contac radio et/ou poussoir ouvre-ferme Kontakt Funkgerät und/oder Taste Öffnen-Schließen Contacto radio y/o pulsador de apertura-cierre Lampada spia 24V Open gate pilot lamp 3W max. These contacts must be connected together if thei are not used. [. . . ] : if you wish to change the code on your transmitters in the future, simply repeat the procedure described above. In the case of installation of two motors, connect the first gearmotor (E600A) in parallel with the second (E601). - Move the gatewing to a distance of approx. [. . . ]