User manual CAME DIW 01

[. . . ] 4) INSTALLATION OF CIRCUIT CARD RADIOFREQUENCY BOARD EXEMPLE : CANAL 9 3) CHOIX FONCTION RELAIS RECEIVER MOTHERBOARD EXEMPLE : MONOSTABLE TEMPORISEE REGLABLE CODING THE RECEIVER CARTE RADIOFRÉQUENCE 1) program the code on the 20-way dip-switch 2) program the channels (see table) on the 4-way dipswitch 3) program the relay functions (see table) on the 2-way dip-switch 4) If necessary (for output OUT1, 2 and 3), insert the TSF04 radio circuit cards into their sockets - EVENTUELLE! [. . . ] MONOSTABLE with TIMING ADJUSTABLE from1 till 50 sec. A MANUAL MANUAL CODING 1) Activate the bridge connection on the transmitter strip (see detail A) 2) Press the key to be coded PONTE INSERITO JUMPER ON PONT BRANCHÉ BRÜCKE AKTIVIERT PUENTE CONECTADO 3) Press key P1 for ON and press P2 for OFF, which is the same dip-switch settings (code and channel) programmed for the selected output (OUT4 in the example) on the receiver 4) Deactivate the bridge connection (set to the position indicated by the dotted line on detail A), and check the coding done - REPEAT POINTS 1) THROUGH 4) ON EACH KEY ESEMPIO: SEQUENZA PRESSIONE TASTI PER CODIFICA TASTO P3 TRASMETTITORE 4 CANALI EXAMPLE: KEYPRESS SEQUENCE TO CODE P3 KEY ON 4 CHANNEL TRANSMITTER EXAMPLE: SEQUENCE PRESSION TOUCHES POUR CODIFICATION TOUCHE P3 EMETTEUR 4 CANAUX BEISPIEL: TASTENDRUCKFOLGE ZUM KODIEREN DER TASTE P3 DES 4-KANALFUNKSENDER EJEMPLO: SEQUENCIA PULSACIÓN TECLAS PARA CODIFICACIÓN TECLA P3 TRANSMISOR 4 CANALES P3· Be sure to connect the cable to the output (OUT1in the figure) that was previously selected 4) Wait for at least one second. 5) Set the functions dip switch to the preferred setting (if necessary) - REPEAT POINTS 3) AND 4) ON EACH KEY. P4) Follow the same procedure (both for manual coding and coding via cable) cable as for the T154. [. . . ] P4) Follow the same procedure (both for manual coding and coding via cable) cable as for the T154. [. . . ]