User manual CAME EMEGA

[. . . ] - Insert the motor into the base-guide in alignment with the 4 pre-drilled holes. Secure the motor using the two nuts and bolts supplied with the unit. Then attach the transmission systems to the uprights of the doors in alignment with the motor. - Raise the door to the fully-open position and measure the length of “B” (see fig. [. . . ] - Remove the screw and washer from the shaft and fit the release knob. Rotate the release knob in order to release the motor as shown in fig. 8(this facilitates connection of the square shaft/transmission tube/ arm). - Fit the two couplings to the transmission tube. Connect the transmission tube to the square motor drive shaft and then to the arm. - Fit the couplings and the plates to the end of the tube and tighten the anchor screws to secure them in position (fig. The procedure is identical to that described previously, though with the following exceptions: - fit the base-guide over the door upright. - use the E781A set, which should be fitted to the upright on the side opposite the motor. NOTE FOR LATERAL INSTALLATION OF TWO MOTORS NOTA PARA LA INSTALACIÓN LATERAL DE DOS MOTORES The procedure is identical to that described for central installation of the motor, though with the following exceptions: - fit the two base-guides over the door uprights as shown above. - for version E1024 only: fit the transmission tube E782A to ensure synchronized movement of the two motors and correct balancing of the door. If necessary, move the upper arm to the most suitable hole on the bracket. - Fit the base-guide E001 and the anchor bracket as shown in fig. Fit the motor and the transmission system as shown on page 7 and fit the articulated arms E783 as shown in fig. Connect up the wiring and perform the necessary adjustments. Note: for lateral installation with one or two motors, refer to page 11. - Fit the base-guide E001 and the anchor bracket as shown in fig. - Fit the motor and the transmission system as shown on page 7 and fit the articulated arms E783 as shown in fig. Connect up the wiring and perform the necessary adjustments. Note: for lateral installation with one or two motors, refer to page 11. - Fit the motor and the transmission system as shown on page 7 and fit the curved telescopic arms E786A. [. . . ] Perform this stop with the motor stopped. Vite di sbloccaggio cordino Vite di bloccaggio cordino Release cablecable anchor screw Release anchor screw Vis de blocage de la cordelette Sujetador de la cuerda Seilbefestingungsschraube Sujetador de la cuerda MANUNTENZIONI PERIODICHE PERIODIC MAINTENANCE OPERATIONS MANTENIMIENTO PERIÓDICO Il gruppo non necessita di alcuna manutenzione specifica. However, as a precaution and in case of heavy-duty service, it is advisable to check the cable connected to the motor and to grease the bushings, the arms and the bearing guides at regular intervals. It Hereby declare, under their own respons ibility, that the product/s called . [. . . ]