User manual CAME F1000

[. . . ] - Guaranteed for 24 months, unless tampered with by unauthorized personnel. - For heavy-duty service, the E 1024 version should be used. [. . . ] If distance B is 300 to 380 mm, distance A Sin enbargo si B está comprendido entre must be at least 150 mm 300 y 380 mm, A debe medir 150 mm como minimo. - Use ø8 screws and ø14 screw anchors to mount the base plate on the pillar. - Attach bracket “A” to the gate wing (use ø8 screws or wlds). Be sure to respect the offsets of 450 mm. - Insert the straight semi-arm, without letting it outside the drive shaft. Apply the flared washer, the M6x20 screw and block the semi-arm trought the two grains. During opening: release and move the door to the open position desired. Turn the upper cam until the microswitch is activated and screw the screw in the related cam. During closure: release and move the door to approximately 100 mm. Turn the lower cam until the microswitch is activated and screw the screw in the related cam. E N G L I S H After assembling the unit, connecting up the wiring and performing adjustments, proceed to jam the motor again and insert the cover fitting it using the four screws supplied with the unit. ) complete of surety-container, release hand grip and push-button. [. . . ] MANUFACTURER’S DECLARATION As per Enclosure II B of Machinery Directive 98/37/CE Enclosed with the technical documentation (the original copy of the Declaration is available on request) The representatives of CAME Cancelli Automatici S. It Date of the present declaration 07/12/2001 Also, they furthermore represent and warrant that the product/s that are the subject of the present Declaration are manufactured in the respect of the following main harmonized provisions: EN 292 PART 1 AND 2 EN 12453 EN 12445 EN 60335 - 1 EN 60204 - 1 EN 50081 - 1 AND 2 EN 50082 - 1 AND 2 MACHINERY SAFETY. [. . . ]