User manual CAME F7000

[. . . ] 9x13 screw and remove the cover from the gearmotor unit (3). Insert the gearmotor in the base-plate in correspondence with the 4 holes and secure it with the two M8x90 screws and related M8 nuts provided (4). [. . . ] Electrical connection for gates with lefthand door (internal view) fig. C 1 2 1 2 F IB LIN 5A US ILI EA QMRO AD C UA DO O N F IB LIN 5A US ILI EA QMRO AD C UA DO O N Z5 A Z5 A F 7001 9 F 7001 Collegamenti elettrici al quadro elettrico ZA3 - ZA4 - ZM2 // Electrical connections to the ZA3 - ZA4 - ZM2 board // Branchements électriques au tableau ZA3 - ZA4 - ZM2 // Stromanschlüsse an die Schalttafel ZA3 - ZA4 - ZM2 // Conexiones eléctricas al cuadro ZA3 - ZA4 - ZM2 Installare il quadro comando e procedere ai collegamenti elettrici come indicato in figura. Install the electrical control panel and connect the wiring as indicated. Adjustments of the microswitches with gearmotor installed on the left-hand side (internal view). In opening: release the gearmotor (1) and allow the door to reach the opening position desired (2). Turn the lower cam clockwise until the microswitch is inserted and lock it with the central screw (3). In closing: allow the door to reach the closing position desired (4). Safety Photocells can be connected to abtain: - Re-opening during closure (2-C1), if the photocells identify an obstacle while the gate is closing, they will reverse the direction of movement until the gate is completely open; - Total stop (1-2), shutdown of gate movement without automatic closing, a pushbutton or radio remote control must be actuated to resume movement. optional accessories Adjustments - Automatic closure time; - Delay in closing of the M2 motor; - Operating time. - 12V Electric lock (ES-ES); - Open gate pilot lamp (3W max. Lamp that signals the gate is open, turns off when the time fixed for the gate’s closing has elapsed (10-5). The automatic closing timer is automatically activated at the end of the opening cycle. The preset, adjustable automatic closing time is automatically interrupted by the activation of any safety system, and is deactivated after a STOP command or in case of power failure; - "Operator present". Gate operates only when the pushbutton is held down (the radio remote control system is deactivated). [. . . ] B The first encoding operation must be carried out whilst keeping the J jumpers positioned for channels 1 and 2 as per fig. B for any subsequent settings on different channels. [. . . ]