User manual CAME G4041

[. . . ] To carry through the wire to the header, drill a wiring hole (ø 8mm or 5/16”). After drilling the holes, remove the Mounting Template. Note Be sure that the mounting height is within the value of those in "SPECIFICATION. " Plug the Connector for the sensor to that for the cable. [. . . ] Adjust the detection area and set the various Switches. €) Note Make sure that you connect the cable correctly to the Control Unit of the door before turning the power on. Note Connect the cable when main power is turned off. Note When passing through the cable to the hole, make sure not to tear shield: otherwise it may cause electric shock or breakdown of sensor. DETECTION AREA Detection Areas are shown in the figure below. After adjustment, turn the power off and on again, be sure to walk-test all of detection areas. *The values of the chart blow is of the Emitting Spots, but not of the Detection Area. The actual Detection Area may become smaller depending on the ambiance light and the colour / material of object and the floor as well as the entry speed of object. 25 A F 1st Row 2nd Row 3rd Row 4th Row E B C D : Emitting Spot : Detection Area Provided Detection Row type Presence Detection Motion Detection 1st 2nd 3rd 4th A 6’ 6 3/4” 7’ 2 5/8” 8’ 2 7/16” B 11” 1’ 3/16” 1’ 1 3/4” C 2’ 2 3/4” 2’ 5 1/2” 2’ 9 9/16” D 3’ 10 7/16” 4’ 3 3/16” 4’ 10 1/4” E 6’ 10 11/16 7’ 6 9/16” 8’ 6 3/8” F 6 5/16” 7 1/16” 7 7/8” [ feet , inch ] 8’ 10 5/16” 9’ 10 1/8” 1’ 2 15/16” 1’ 4 9/16” 3’ 1/4” 3’ 4 3/16” 5’ 2 5/8” 5’ 9 11/16” 9’ 2 1/4” 10’ 2 1/16” 8 11/16” 9 13/16” ADJUSTMENT 1 Adjusting the Pattern Width Setting the Width adjustment shutters Opens All Areas Eliminate Eliminate Eliminate 1 2 7 8 1 2 7 8 Adjusting the Width Angle Left or Right : between 0 to 7 (3. 0m Note Setting the pattern for exact door opening may give a slow response to side approaching traffic. If dirty, wipe the window with a damp cloth. Do not disassemble, rebuild or repair the sensor yourself; otherwise electric shock may occur. Contact your installer or the sales engineer if you want to change the settings. Do not place an object that moves or emits light in the detection area. SOLUTION Check the wiring and the connector. Wipe the detection window with a damp cloth. Set the different frequency position each other. Adjust the detection area to deep (outside). This sensor is equipped with the anti-malfunction. However, pay attention when installing as malfunction may occur under the left conditions. [. . . ] However, pay attention when installing as malfunction may occur under the left conditions. dOSE NOT OPERATE CONSISTENTLY Sensitivity is Low. There is an object that moves or emits light in the detection area. OPERATES BY ITSELF (GHOSTING) Detection area has interfered the area of another sensor. [. . . ]