User manual CAME G6000

[. . . ] The access door for inspection can be locked onto the case with a personal key. B - Mounting base in galvanized steel, complete with four anchor stays and bolts for anchoring the case to the pavement. [. . . ] B A C GB 2) - Place the unit on the concrete base: it is good practice to install the case so that the access door can be opened from the interior of the installation site (see on page 8). Mount the barrier as follows: first, determine the length of barrier required. Then, mount the barrier holder with the four screws provided. Regulated mechanical stop B and transmission arm C to adjust the barrier rod for linearity in the vertical and horizontal positions. If the final configuration of your barrier requires a change in the position of the springs (see illustrations), unlock the gear motor and change the position of the springs (do not throw away the spring if not used). If precise balancing of the barrier rod is required, see the next page. E L A fissaggio molle attach springs fixation ressorts Federnhalterung enganche resortes con rastrrelliera o appoggio mobile with rack or mobile support avec tablier ou appui mobile mit Schrankengitter oder feste Stütze B Lm Posizione molle Springs position Position ressorts Federneinstellung Posiciòn resortes <4 1B <5 1A <6 2B 1B -7- I Per bilanciare con precisione l'asta: A 200 max. - Automatic closing time Important: isconnect the unit from the main power lines before carrying out any operation inside the unit. GB Note: when an obstacle is encountered, the amperometric locking device intervenes as follows: a) if in the aperture phase, the bar stops; b) if in the closure phase, the movement of the bar is reversed. : In situation (b), if an obstacle is detected three times, the bar stops during aperture, and automatic closure is disactivated. Use the keyboard or the radio transmitter to resume movement of the bar. 15A line fuse 2A accessories fuse "Function selection" dip-switch Radiofrequency board socket (see table) TCA trimmer: automatic closing time adjustment SENS trimmer: amperometric sensitivity adjustment Button for memorizing code numbers Radio code / automatic closing signal LED Connectors for power supply motor Connectors for connection to battery charger (LB35) Jumper for selection of type of control for button in 2-7 GB F 1 2 3 4 5 6 7 8 9 10 11 Plaque à bornes de connexion Fusibles de ligne 3. When connecting the photocells (TX and RX), observe the correct polarities. )See DIP 2 for command type Connector (N. [. . . ] Keep the "PROG" key pressed on the base card, the signal LED will flash (see fig. 1), and with a key on the transmitter the code is sent, the LED will remain lit to signal the successful saving of the code (figure 2). [. . . ]