User manual CAME KIT A3000

[. . . ] BEFORE BEGINNING INSTALLATION OF THE AUTOMATION SYSTEM, CHECK THE FOLLOWING: - the structure of the gate must be sufficiently strong; the hinges must function efficiently and there must be no friction between the moving parts and fixed parts; - measurement C must not be greater than the value shown in Tab. [. . . ] if measurement A is increased , the angle of aperture is increased. This therefore increases the peripheral speed and reduces the thrust exerted by the motor on the gate. With the gate closed, attach the fixing plate with the front bracket to the gate wing. The anchor plate must be horizontally aligned with the rear bracket and measurement E must be observed. - Slide the microswitch unit along the microswitch-support rod until it is inserted by contact on the microswitch unit actuation runner. - Fix the microswitch by tightening the respective screws. - Attach the rear bracket together with a supplementary bracket and fasten both to the column. - Open the gate (maximum 90°) and measure "E" (see Tab 4), then fasten the front bracket to the gate. [. . . ] 0 Reference code to request a true copy of the original: DDF B EN A020 ver. [. . . ]