User manual CAME M7471

[. . . ] Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] GExample 5H Net Audio operating screen > > > > > > NET AUDIO/USB(MAIN ZONE) CAME:[M7471] > Favorites Internet Radio Media Server Flickr Napster Pandora -60 -50 -40 -30 -20 -10 0 Q0 Click the menu item from which you want to make settings. The display on the right becomes the individual setting screens. Q1 Click “SAVE” when you want to save settings, and click ZONE CONTROL “LOAD” when you want to call settings. IPod Q5 Enter figures or click “<” or “>” to make the setting, and then Direct click “Set”. Various memory functions Q9 nnPersonal memory plus function W1 W2 Rhapsody [1/7] Party Start W0 End(Att ON) PRESET MEMORY A1 ONE REPEAT ALL -70 -60 This function sets the settings (input mode, surround mode, HDMI output mode, MultEQ® XT, Dynamic EQ®, Dynamic Volume™, audio delay etc. 0dB > ∞ -80 The surround parameters, tone settings and the volumes of the different speakers are stored for the individual surround modes. q6 Click “ON” when performing Top Menu Link Setup. When set up, return to the top menu from each operation screen. (Default setting : “OFF”) Q7 Click this item to return to the top menu. W0 Click “v” to select the preset channel you want to play. W1 When registering presets, click “v” to select the channel you want to register, and then click “MEMORY”. € When certain digital signals are being input, noise may be output from the ZONE2 audio output connectors. Information In this case, the volume for ZONE2 can be adjusted on the amplifier. 59 ENGLISH Playback Adjusting the volume SELECT to Use VOL df to adjust the volume. GAdjustable rangeH – – – –80dB – –40dB – 18dB (When the “Volume Display” (vpage 84) setting is “Relative”) GAdjustable rangeH 0 – 41 – 99 (When the “Volume Display” (vpage 84) setting is “Absolute”) • At time of purchase, “Volume Limit” (vpage 84) is set to “–10dB (71)”. Quick select function It is also possible to save three settings for ZONE2. The remote control unit switches to the operating mode for ZONE2. NnSaving the settings below 1 Set the itemssave. To the settings you want to q Input source (vpage 60) w Volume (vpage 60) 2 Press AMP. 3 Press ZONE/DEVICE ON to turn on the ZONE2 power. the indicator on the display lights. Input source select buttons • Also, pressing any of input source select button in standby mode turns on the power. [. . . ] Wait a while stations, “Server before trying again. full” or “Connection Down” is displayed and station cannot be connected to. € Network’s signal transfer speed is slow or communications lines or radio station is congested. When playing broadcast data with a high bit rate, the sound may be broken, depending on the communications conditions. [. . . ]