User manual CAME MA7041A

[. . . ] Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] E Use ui to select “ONCE” or r Use o p to select “ON” or “OFF” for the alarm, then press ENTER. The alarm settings are displayed after this. € When set to “OFF”, time operation is disabled, but the alarm settings remain unchanged. Setting the sleep timer Use this function to automatically switch the power to the standby mode after a specific amount of time (minutes). The sleep timer can be set to up to 90 minutes, in steps of 10 minutes. Preparations Use select 7 thenui toENTER“minutes” for the alarm start time, press or p. ON TIME AM10:30>AM12:00 Press SLEEP during playback and select the setting time. SLEEP 90 min SLEEP 60 min SLEEP 30 min SLEEP 80 min SLEEP 50 min SLEEP 20 min SLEEP 70 min SLEEP 40 min Operations SLEEP 10 min SLEEP OFF 8 Use ui to select “hours” for the alarm stop time, then press ENTER or p. The alarm settings are displayed for 3 seconds. € After about 5 seconds, the setting is entered and the display returns to as it was before. NnCanceling the sleep timer select 9 Use ui toENTER“minutes” for the alarm stop time, then press or p. If “INITIALIZE” does not display in step 2, start over from step 1. Operations F Part names and functions vpage 25 F Other information vpage 30 F Troubleshooting vpage 31 F Specifications vpage 33 F Index vpage 33 Informations DISC 24 Part names and functions Front panel For buttons not explained here, see the page indicated in parentheses ( ). Preparations Image when viewed from the top of the front panel Q3 Q2 Q1 Q0 o q Power operation button (X)· (30) t Headphones jack (PHONES) When the headphones are plugged into this jack, audio will no longer be output from the connected speakers. Operations NOTE To prevent hearing loss, do not raise the volume level excessively when using headphones. (29) Q3 Display q w e r t y u i DISC 25 Display i u y t r e Rear panel For buttons not explained here, see the page indicated in parentheses ( ). (11, 18, 20) t TOTAL indicator Lights when the total number of tracks and total time of the CD are displayed. TONE:  Lights when the tone (bass/treble) is being adjusted. (4) DISC 26 Remote control unit This section explains the buttons used to playback each source. Preparations Buttons that work with all sources (CD, TUNER, iPod and USB) q w e r q SLEEP button· (9, 13, 14, 21, 23) Buttons that work with CDs The buttons listed at “Buttons that work with all sources” can also be used. (8) Informations Q2 r t o y u Q1 Q0 i o DISC 27 Remote control unit nnButtons that work with the tuner The buttons listed at “Buttons that work with all sources” can also be used. NnButtons that work with iPods or USBs Preparations The buttons listed at “Buttons that work with all sources” can also be used. [. . . ] In the case of a CD or DVD Player, please enclose ONE (1) disc that the unit has failed with for test reasons. If your product does not require service, but you have questions regarding its operation, please contact our Technical Services Department as listed below. This warranty gives you specific legal rights, but you may also have other rights which vary from state to state. This Warranty may not be altered other than in a writing signed by an officer of Denon Electronics USA, LLC. [. . . ]