User manual CAME MI6140

[. . . ] Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] When the power is turned back on, the settings are restored. 60 ENGLISH Playback in ZONE2/ZONE3 (Separate room) • You can operate this unit so as to enjoy audio in a room (ZONE2, ZONE3) other than the MAIN ZONE (room where the unit is located). € You can simultaneously play back the same source in both the MAIN ZONE, ZONE2 and ZONE3. You can also play back separate sources in the MAIN ZONE, ZONE2 and ZONE3. Simple version w Zone playback by audio output (PRE OUT) nnAudio connections (ZONE2, ZONE3) ZONE2 MAIN ZONE This unit The audio signals of this unit’s ZONE2 and ZONE3 audio output terminals are output to the ZONE2 and ZONE3 amplifiers and played on these amplifiers. ZONE3 The source selected for ZONE2 is also output from the recording output connectors. Basic version Audio output There are two methods to do this, as described below. q Zone playback by speaker output w Zone playback by audio output (PRE OUT) Use an external amplifier. AUX IN L R L R AUX IN q Zone playback by speaker output The ZONE2 and ZONE3 audio signals are output from this unit’s SURR. bACK/AMP ASSIGN speaker terminals using the amplifier assignment function. We recommend using high quality pin-plug cables for audio connections in order to prevent noise. € To cancel, either adjust the volume or press MUTE again. € The setting is canceled when the zone’s power is turned off. Mode 3 In the zone operate, for which you want to press and hold the desired QUICK SELECT until “Memory” appears on the on-screen display or display. The audio signal of the selected source is output to ZONE2 or ZONE3. € Turn SOURCE SELECT after pressing ZONE2/3 / REC SELECT on the main unit to select an input source. You can adjust the tone and volume for ZONE2 and ZONE3 in “Zone Setup” (vpage 86) in the menu. gQuick select defaultsH Input source Z2/Z3 QUICK SELECT 1 BD Z2/Z3 QUICK SELECT 2 SAT/CBL Z2/Z3 QUICK SELECT 3 DOCK Volume –40dB –40dB –40dB nnRecalling the settings 1 Switch ZONE SELECT “ZONE2” or “ZONE3”. When power for both MAIN ZONE and ZONE2 is set to ON, power of the MAIN ZONE only can be turned off. Select “MAIN” in step 1 then press ZONE/DEVICE OFF. To The remote control unit switches to the operating mode for ZONE2 or ZONE3. The 2 Press QUICK SELECT at which are settings you want to call out saved. [. . . ] Wait a while stations, “Server before trying again. full” or “Connection Down” is displayed and station cannot be connected to. € Network’s signal transfer speed is slow or communications lines or radio station is congested. When playing broadcast data with a high bit rate, the sound may be broken, depending on the communications conditions. [. . . ]