User manual CAME MR8003

[. . . ] Retain Instructions - The safety and operating instructions should be retained for future reference. 3 Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. Follow Instructions - All operating and use instructions should be followed. Cleaning - Unplug this product from the wall outlet before cleaning. [. . . ] Displayed and the display on the main unit is turned off. €¢ If the HDMI input connector is selected, video outputs are output In the PURE DIRECT mode. €¢ The channel level and surround parameters in the PURE DIRECT mode are the same as in the DIRECT mode. /11> 46 ENGLISH Surround Parameter Adjust surround sound parameters The parameters (items) which can be adjusted differ depending upon the following conditions. €¢ Whether an input signal is present (when playing) or not (when stopped, etc. €¢ The type of input signal • The type of surround mode For details of which parameters can be adjusted in each surround mode, see "Surround Modes and Parameters" (GT'page 76, 77). • Menu screen • 4. Parameter fJ Cinema EO Soften the treble range of movie soundtracks for better understanding. The adjustable parameters differ for the different surround modes (GT'page 76, 77). Compress dynamic range (difference between loud and soft sounds). [Selectable items] I I Auto I Low Middle High OFF o Surround Parameter o Mode fJ This can be set in the Dolby TrueHD mode. Width (Center Width) Assign center channel signal to front left and right channels for wider sound. Mode for discrete playback of surround back signals included in 7. J - 7 1m DelayTime Adjust delay time to control sound stage size. [Selectable items] ~ OFF * 1: This Example: Playing Dolby Digital software (with EX flag) • When" AFDM" is set to "ON", the surround mode is automatically set to the DOLBY + PLllx CINEMA mode. €¢ To play in the Dolby Digital EX mode, set "AFDM" to "OFF" and "SB CH Out" to "MTRX ON". * * * [Variable range] 0 ms - 130 ms I - 110 ms III Effect (Effect Level) Adjust the strength of the surround effect. , can be selected when "Surround Back Speaker" is set to "2spkrs" at the menu "Manual Setup" - "Speaker Setup" - "Speaker Configuration" setting (iGT'page 29). 2: This can be selected when "Surround Back Speaker" is set to "2spkrs" or "lspkr" at the menu "Manual Setup" - "Speaker Setup" -"Speaker Configuration" setting. 3: This can be selected when playing DTS sources. 4: This can be selected when playing DTS sources including a discrete 6. If the playback mode does not switch automatically even when "AFDM" is set to "ON", set "SB CH Out" to "MTRX ON" or "PLIIx CINEMA". [. . . ] Please enclose ONE (I) disc that the unit has failed with for test reasons. €¢ t, ' r , , • • • " • • ~ '_: • • • • • '_:_', • ~ • require service, but you have questions regarding its operation, please contact our Technical Services Department as listed below. This warranty gives you specific legal rights, but you may also have other rights which vary from state to state. This Warranty may not be altered other than in a writing signed by an officer of Denon Electronics USA, LLC. [. . . ]