User manual CAME PB1100

[. . . ] Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. Follow Instructions - All operating and use instructions should be followed. Cleaning - Unplug this product from the wall outlet before cleaning. do not use liquid cleaners or aerosol cleaners. [. . . ] 30 ENGLISH Parameter S Symb91s used , to indicate, buttons in this, man~itl , , . Parameter is displayed, , ' Surround Parameter Adjust surround sound parameters, • --: Button located on both the main unit and the remote control . BUTTON unit Button only on the main unit . [BUTTON] Button only on the remote control unit The parameters (items) which can be adjusted differ depending upon the following conditions. €¢ Whether an input signal is present (when playing) or not (when stopped. €¢ The type of input signal • The type of surround mode For details of which parameters can be adjusted in each surround mode. Only those parameters which can be adjusted uhder the current . €¢ If no adjustment is made for a period of about 5 seconds. The adjustments made up that point are registered and the AVR· M 31 ENGLISH DMode Select the mode to match the source (cinema source, music source, etc. Comp Compress dynamic range (difference between loud and soft sounds). II Center Width Assign center channel signal to front left and right channels for wider sound. MTRXON, • The surround channel signals undergo digital matrix processing and are output from the surround back channels. I: The input from the subwoofer channel is not attenuated. Set this to "ON" if the subwoofer channel level seems too high when playing audio signal. - &U8I; * 4 : Signal [Selectable items] * 1: This can be selected when "Surround Back Speaker" is set to * "2spkrs" at the "System Setup" - "Speaker Setup" setting (Grpage 22). 2: This can be selected when "Surround Back Speaker" is set to "2spkrs" or "1 spkr" at the" System Setup" - "Speaker Setup" setting. 3: This can be selected when playing DTS sources. 4: This can be selected when playing DTS sources including a discrete 6. 1-channel signal identification signal. I;:'~:';(l: ~ Operating from the main unit or remote control unit Press MULlED. LJR" or "Audyssey Flat" is selected, the Audyssey MultED indicator lights green. €¢ After running Auto Setup, if the Speaker Configuration, Distance, Channel Level and Crossover Frequency have changed without increasing the number of speakers measured, the Audyssey MultED indicator lights red. [. . . ] It may be taken or shipped to any authorized CAME service station or CAME ELECTRONICS (if you are uncertain as to :eh~r~:;p~~~;~~~ ~:~:i; ~;v~~~ authorized. ) In all other cases, the following procedures apply whenever your unit must a. You are responsible for transporting your unit or arranging for its transportation. If shipment of your unit is required; You must pay the initial shipping charges, but we will pay the return shipping charges if the repairs are covered by the Warranty. [. . . ]