User manual CAME UNIPARK

[. . . ] This Operating Manual is intended to acquaint you with the many unique features of your state of the art Telemetry-capable radio control system. Please read this operating manual carefully prior to use so that you may obtain maximum success and enjoyment from the operation of your new radio control system. 4GHz FHSS-4T radio control system has been designed for the utmost in comfort and precise control of all types of model cars and boats. We wish you the best of success and fun with your new purchase! [. . . ] Limiting the maximum travel of the steering wheel will increase the sensitivity of the steering. We recommend setting negative Exponential to soften the control feel around Neutral. For more information, see the Exponential and ARC Adjustment section on pages 23 ~ 25. Wrist strap anchor A wrist strap anchor is included that can be installed onto the transmitter to facilitate the use of a wrist strap (not included). To install the wrist strap anchor, follow the steps below: 1) Remove the self-tapping screw (A) from the transmitter, using a # 1 philips head screwdriver. 2) Slide the wrist strap anchor into the mounting slot in the back of the transmitter, then reinstall and tighten the self-tapping screw. When installing the wrist strap anchor, note its orientation. The U-Shaped groove in the base of the wrist strap anchor should be pointing down. page 15 B A GENERAL LCD and programming keys The MT-4 2. 4GHz FHSS-4T transmitter features a Push-Button Rotary Dial and a Back/Cancel key that are used to facilitate transmitter programming. This section describes the main areas of the different Multi-Function LCD screens, in addition to summarizing the functions of the Push-Button Rotary Dial and the Back/Cancel key. Telemetry Signal Indicator: Indicates the current signal strength of the Telemetry connection between the transmitter and receiver. The Telemetry Signal Indicator will only be displayed when the receiver is turned 'ON' and there is a Telemetry connection Active. The Throttle Offset Indicator will only be displayed if a Throttle Offset percentage value is programmed. Throttle Program Indicator: Indicates up to four different programming options that are currently programmed to the Throttle channel. The Throttle Program Indicator will only be displayed if a Throttle channel programming value is programmed. Throttle Trim Display: Displays the current position of the Throttle Trim Switch. Timer Display: Displays the time of the currently selected Timer. Timer Type Indicator: Indicates the current Timer Type selected, either LAP or INT (Interval). Voltage Alert Indicator: Indicates the currently programmed Voltage value that the receiver Voltage Alert alarm will sound at. voltage Display Monitor: Displays the current receiver battery voltage in bar graph format. Programming keys Overview and functions Moving around the different Multi-Function LCD screens and programming the transmitter is accomplished using the Push-Button Rotary Dial and the Back/Cancel key. [. . . ] This is useful to control simple ON/OFF functions, such as a reverse servo for a transmission or a mechanical switch to turn lights 'ON' and 'OFF', etc. The Step Auxiliary Position value can be adjusted while you're driving using one of the four Trim Switches, the Rotary Dial or the Auxiliary Lever. The Step Auxiliary function can be toggled 'OFF' and 'ON' by assigning Auxiliary 1 to one of the two Push-Button Switches. This allows you to control when the Auxiliary 1 servo travels to the programmed Step Auxiliary position. [. . . ]