User manual CAME ZA2S

[. . . ] Take care when the cooker hood is operating simultaneously with an open fireplace or burner that depend on the air in the environment and are supplied by other than electrical energy, as the cooker hood removes the air from the environment which a burner or fireplace need for combustion. The negative pressure in the environment must not exceed 4Pa (4x10-5 bar). Provide adequate ventilation in the environment for a safe operation of the cooker hood. Follow the local laws applicable for external air evacuation. [. . . ] - Take the upper part of the structure B (Fig. 4) and insert the 3 slots onto the 3 screws that are not completely tightened. Drive in the fourth screw X and tighten the remaining 3 to allow definitive blocking of the upper part of structure B. - Take the lower part of the telescopic structure C and insert it into the upper structure B (Fig. Adjust the height by referring to the amounts indicated in (Fig. 14a) and block it using the 8 screws G that are supplied (Fig. - Suction version: Fix the flexible pipe to the prepared air evacuation hole (Fig. - Filtering version: Fix the flexible pipe to the deflector M and fix screw I as indicated in (Fig. - The charcoal filters are already fitted to the appliance (Fig. - Take the upper chimney piece and fix it to the structure using the 2 screws A (Fig. Join the lower chimney piece with the upper one and fix it carefully using adhesive tape L (Fig. To carry out this operation, press the “B” and “D” buttons together for a few seconds with the motor off. - To match the cooker hood with a gas hob, press the “B“ button. a “P” and a “0” will alternate on the display. - To match the cooker hood with an electric hob, press the “D“ button. a “P” and a “1” will alternate on the display. To complete the setting, press the “B+D” buttons for a few seconds. The appliance has already been set for an electric hob by the manufacturer. Intensive: This function allows you to temporarily increase the motor’s extraction rate for about 10 minutes. To activate the function, press the “D“ button after selecting extraction rate level 3. After 10 minutes, the appliance will return to operate at extraction rate level 3. Timer: This function allows you to set the appliance to run for 15 minutes and then switch off. [. . . ] - After a few washes, the colour of the filters may change. This does not mean they have to be replaced. If the replacement and washing instructions are not followed, the anti-grease filters may present a fire hazard. € The active carbon filters are used to purify the air which is released back into the room. [. . . ]