User manual CAME ZC2C

[. . . ] Children should not be allowed to tamper with the controls or play with the appliance. Never use the hood without effectively mounted grating!The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. [. . . ] Installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 60cm from electric cookers and 75cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. ducting version The cooker hood has an upper air duct B1 and an optional rear air duct B2* , for external fumes exit. Select the suitable air duct and apply the flange C supplied, ensure to close the unused hole duct with cap D* supplied if provided. Note: in some models upper hole B1 is supplied closed: Press firmly to detach the detachable part that closes the outlet hole and remove it. The detachable part cannot be mounted in position again. Carry out this operation only if you are sure of the type of installation to make. In some models the rear hole duct is not easily accessible, even when the tap (if mounted) is removed, in this case remove the plastic piece E1 or E2 that is blocking the hole duct, by unwinding using pliers and cutter. Check that the filter/suction selector (inside the cooker hood) G is in the suction (A) position. Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. Replacing lamps Disconnect the hood from the electricity. Prior to touching the light bulbs ensure they are cooled down. Replacing lightbulbs 40W - Unscrew the damaged light bulb and replace with an incandescent oval light bulb with a maximum of 40W E14. Remove the grill in order to reach the light bulb area. Replacing the halogen bulbs - Access the light compartment – extract the lamp cover by levering it off with a small screwdriver or similar tool. Only use halogen bulbs of 20W max (G4), making sure you do not touch them with your hands. Close the lamp cover (it will snap shut). If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. grease filter Traps cooking grease particles. If situated inside the support grill, it may be one of the following types: Paper filter must be replaced once a month or if colouring appears on upper side, in such cases the colouring is evident through the grill openings. Sponge filter should be washed with hot soapy water once a month and replaced every 5 to 6 washes. [. . . ] Not : P r ile contrasemnate de simbolul “(*)” sunt accesorii furnizate numai pentru câteva modele sau sunt p r i care nu sunt în dota ie i trebuie s fie cump rate. Aparatul nu este destinat pentru a fi folosit de c tre copii sau persoane cu capacit i fizice senzoriale i mentale reduse sau care nu au experien a i cuno tin a adecvat , numai în cazul în care acestea sunt sub supraveghere sau le sunt date instruc iunile de folosire a aparaturii de c tre o persoan responsabil cu siguran a acestora. P r ile componente cu care am putea intra in contact se pot înc lzi considerabil în momentul în care se folosesc împreun cu aparatura pentru preg tit mâncarea. n ceea ce privesc m surile tehnice i de siguran care trebuie s fie adoptate pentru evacuarea fumurilor este strict necesar s respecta i regulamentele în vigoare i s apela i la autorit ile competente locale. [. . . ]