User manual CAME ZR22

[. . . ] To cancel the auto-restart function, repeat the above steps. SAFETY PRECAUTIONS • Do not install the appliance if it is connected to the power supply. € The Installation and service/repair must be performed by a qualified technician, in compliance with the producer's instructions and following local safety norms. Do not repair or replace any parts of the appliance unless it is specifically written in the user instructions. [. . . ] € Set temperature will decrease by 3°C at most if the appliance operates in heating mode for 3 hours. *Note: In cooling mode, if room temperature is 26°C or above, set temperature will not change. Note: Heating is NOT available for cooling only air conditioner. oN JET mode • JET mode is used to start or stop fast cooling. Fast cooling operates at high fan speed, changing the set temperature automatically to 18°C. € JET mode can be set when the appliance is in operation. • In JET mode , you can set airflow direction or timer. If you want to quit from JET mode, press any - JET , MODE, FAN, ON/OFF or TEMPERATURE SETTING button, the display will return to the original mode. € The appliance will continue working in JET mode with set temperature of 18°C if you don't quit from it by pressing any of the buttons mentioned above. 14 501932602028:Layout 1 1-12-2008 17:02 Pagina 15 Timer function It is convenient to set the timer on by pressing the TIMER ON/OFF buttons to achieve a comfortable room temperature at the time you get home. You can also set timer off automatically to enjoy a good sleep at night. • Is the temperature set properly?€ Has there been a strong interference (from excessive static electricity discharge, power supply voltage abnormality)?Note that operation will be abnormal, in this case unplug from the power supply and re-plug after 2-3 seconds. € 3 minute delay will occur when changing mode during operation. € This smell may come from another source such as furniture, cigarette etc, which is sucked in the unit and blown out with the air. € Normal behaviour caused by the flow of refrigerant in the air conditioner. • Defrosting sound in heating mode. € The sound may be generated by the expansion or contraction of the front panel due to temperature changes. € Mist is present in the room with low temperature?Normal behaviour due to cool air discharged from indoor unit during COOLING or DRY operation mode. Does not run No cooling or heating air Ineffective control Does not operate immediately Peculiar smell A sound of running water Cracking sound Mist sprays from the outlet 17 501932602028:Layout 1 1-12-2008 17:03 Pagina 18 INSTALLATION INSTRUCTIONS Installation diagram Distance from wall should be over 50mm Distance from ceiling should be over 50mm Distance from the wall should be over 50mm Distance from floor should be over 2000mm Air intake distance from the wall should be over 250mm Air intake distance from the wall should be over 250mm Ai shor out uld let be dist ov anc er e f 50 rom 0m m the wa ll Over 250mm NOTE: The figure above is only a simple presentation of the unit, it may not match the external appearance of the product you purchased. [. . . ] Install Drain Port and Drain Hose (for heatpump model only) The condensate drains from the outdoor unit when the unit operates in heating mode. In order not to disturb your neighbours and protect the environment, install a drain port and a drain hose to direct the condensate water. Just install the drain port and rubber washer on the chassis of the outdoor unit, then connect a drain hose to the port Washer as shown in the figure on the right . Install and Fix Outdoor Unit Drain hose Fix with bolts and nuts tightly on a flat and strong (prepare by user) floor. [. . . ]