User manual CAMPINGAZ CHALUGAZ

[. . . ] Keep it away from parts that are likely to get heated. Connecting the hose: to connect the hose to appliance inlet union, firmly but moderately tighten the hose using 2 suitable spanners: - 14 mm spanner to tighten appliance inlet union. Connect the other end to pressure reducing valve outlet union. - Check tightness in compliance with indications of paragraph D-2. [. . . ] only use the type of gas stipulated by the manufacturer. In France, it is strictly forbidden to use another gas type than Butane. If an empty bottle is in place, read paragraph F"Removing or replacing gas bottle". To install or remove a gas bottle, always operate in a well-ventilated place and never in presence of a flame, spark or heat source (cigarette, electric appliance, etc. Note: if the appliance is new, loosen screws (4) by a quarter turn, lift and remove rear plate (3). D - 1 - Installing gas bottle: - Position the gas bottle on the floor behind the appliance. - Check whether bottle cock and/or pressure reducing valve handle is in "closed" position. - Screw in or engage pressure reducing valve to gas bottle or gas bottle cock (fig. - Install gas bottle through appliance rear so that the hose does not touch appliance metal panels and is not excessively bent or pinched. - Check that the hose runs normally and is neither bent nor pulled. - Do not place the heater just below an electric socket. The appliance should not be returned to service until the leak is removed. Important: In case of gas leak or odour, immediately close bottle cock and/or pressure reducing valve handle. Enhance room ventilation by opening the windows. Ask a specialised technician to check the appliance and proper bottle connection. A leak test should be carried out at least once a year and whenever the gas bottle is changed. OPERATING PRECAUTIONS: DO NOT install the appliance next to a wall, curtains or a sofa or armchair. DO NOT cover the appliance with clothes or other objects. DO NOT move the appliance when in operation. the appliance must ALWAYS be directed to the centre of the room. The appliance must be put in a dry place. This appliance protecting grid is designed to prevent fire hazards or burns and no part shall be permanently removed. [. . . ] - In France, if the expiry date printed on the hose is reached, it must be replaced by a hose compliant with the XP D 36-112 Standard. - Comply with installation indications provided with these new assemblies to be 0. 50 m long , and with the procedure described under paragraph C - 2. - If your appliance is to remain unused for a long period, disconnect gas bottle. [. . . ]