User manual CANDY 1300 SPECIAL EDITION CA231

[. . . ] avoid locating the appliance in moist areas. Too much moisture in the air will cause frost to form quickly on the evaporator. Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. [. . . ] Reversing the Door Swing of Your Wine Cooler This wine cooler has the capability of either opening the door from the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please follow these instructions. NOTE: Before reversing the door , the power must be shut off. All parts removed must be saved to do the reinstallation of the door. This wine cellar has been built with the door hinges on the right. If you wish to change the opening direction, follow the instructions below: 1. Remove the two screws(8) that hold the lower hinge(2) and Make sure to Remove the lower hinge(2). Before placing this lower hinge(2), remove the bolt-pin (9) and reverse the direction of the lower hinge(2). Then install the lower hinge (2) onto the left side of the lower frame with two screws (8). Set the door to its place making sure the door seat at the lower hinge(2). The solution should be about 2 tablespoons of baking soda to a liter of water. Wash the shelves and trays with a mild detergent solution. The outside of the wine cooler should be cleaned with mild detergent and warm water. It may also be necessary to periodically wipe the bottom part of the storage area, as the wine cooler is designed to retain humidity, and condensation may collect there. Maintenance of Your Wine Cooler Power Failure Most power failures are corrected within a few hours and should not affect the temperature of your wine cooler if you minimize the number of times the door is opened. If the power is going to be off for a longer period of time, you need to take the proper steps to protect your contents. Vacation Time During long absences, remove all the bottles; unplug your wine cooler, clean your wine cooler, and leave the door open slightly to avoid possible formation of condensation, mold, or odors. moving Your Wine Cooler Remove all the bottles. Securely tape down all loose items inside your wine cooler. Be sure the wine cooler stays in the upright position during transportation. troubleshooting You can solve many common wine cooler problems easily, saving you the cost of a possible service call. [. . . ] External environment may require a higher setting. The wine cooler does not have the correct clearances. The room temperature is hotter than normal. A large amount of contents has been added to the wine cooler. [. . . ]