User manual CANDY C 7400

[. . . ] Standard daily cycle. 3in1(1pcs) Turning on the Appliance 1 2 3 4 5 6 7 Draw out the lower and upper basket, load the dishes and push them back. It is commended that loading the lower basket first, then the upper one. The expensive and finer chinaware should not be put in. With a little force to ensure the door is properly closed. Press the Start/ to stop washing. [. . . ] But at the end of delayed washing, no sound of the buzzer, only the flash of the time display. If your model have not water softener, you may skip this section. The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliances is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. 1 Remove the lower basket and then unscrew and remove the cap from the salt container. 2 3 4 If you are filling the container for the first time , fill water . Place the end of the funnel(supplied) into the hole and introduce about 1kg of salt . It is normal for a small amount of water to come out of the salt container Carefully screw the cap back on. 4 DETERGENT DISPENSER YOU MAY NOT ADD TOO MUCH DETERGENT TO PREVENT THE FORMATION OF DEPOSITS BECAUSE YOUR DISHWASHERS HAVE SPECIALLY-DESIGNED WATER SOFTENERS. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the" Wash Cycle Table". Your dishwashers use less detergent and rinse aid than conventional dishwashers. Generally, only one tablespoon of detergent is needed for a normal wash load. Also, more heavily soiled items need more detergent. Always add the detergent just before starting dishwasher, otherwise it could get damp and will not dissolve properly. WARNING! Proper Use of Detergent In accorance with En50242 standard, the dispenser should be set on the maximum lever when doing the performance. 5 Loading the Dishwasher Racks. For best performance of the dishwasher, follow these loading guidelines. Features and appearance of racks and silverware baskets may vary from your model. It is preferable to place serving dishes and lids on the side of the racks in order to avoid blocking the rotation of the top spray arm. Pots, serving bowls, etc, must always be placed top down. Deep pots should be slanted to allow water to flow out. Fused electrical supply is required-copper wire only. Time delay fuse or circuit breaker recommended and provide separate circuit serving only this appliance. Outlet should be placed in adjacent cabinet. Make sure that plug on the appliance remains eccessible after installation. Insure proper ground exists before use How to Connect the safety supply hose The appliance must be connected to the water mains using new hose-sets. Water pressure must be between 0, 04 MPa and 1 MPa. If the pressure is below the minimum consult our Service Department for advice. 1 2 3 Pull The supply hoses completely out from storage compartment located at rear of dishwasher. Tighter the screws of the safety supply hose to the faucet with thread 3/4inch. Turn water fully on before starting the dishwasher. WARNING! How to Disconnect the safety supply hose 1Turn off the water. the 2 Releasefromwater pressure by depressing the pressure release button. This relieves water pressure and protects you, and the room, severe splashing. Unscrew The safety supply hose from the faucet. . 3 How to Disconnect the Dishwasher 1 Remove the power cord plug from the wall receptacle. [. . . ] The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. How to Drain Excess Water From Unicouple Hoses If the sink is 34 or higher from the floor, the excesswater in Unicouple hoses cannot be drained directly into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is heldoutside and lower than the sink. 11 Before Calling for service . . Troubleshooting Tips Review the charts on the following pages may make you be free of calling for service. Problem Dishwasher doesn t run Possible Causes Fuse blown, or the circuit breaker acted What To Do Replace fuse or reset circuit breaker. [. . . ]