User manual CANDY CBG62

[. . . ] A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnec t the elec trical plug prior to any maintenance. G) This appliance is not intended for use by young children or infirm persons without supervision H) Young children should be supervised to ensure they do not play with the appliance I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels L) There is a risk of fire if cleaning is not carried out in accordance with the instructions This appliance conforms to the European Directive EC/2002/96, Waste Electrical and Electronic Equipment (WEEE). Assembly and electrical connections must be carried out by specialised personnel. [. . . ] The overall measurements of the cooker hood are given in figure 2. Before proceeding with cooker hood installation, remove grille D by pressing the two side buttons A, as shown in figure 3. Fix the appliance in place using 8 screws (not supplied) which are suited to the type of cabinet. Correctly, first fit the 4 screws A and then the 4 screws B, in accordance with the diagram in figure 4. After fixing the cooker hood to the lower part of the cabinet, place grille D (fig. During this procedure, make sure that grille D is fastened properly. Extraction through an outside wall The appliance expels the fumes through an outside wall or a duct. It is necessary to buy a telescopic pipe in accordance with the standards in use (inflammable) and connect it to flange H (Fig 1A). Recirculation To transform an extractor hood version into a filter hood version, contact your appliance dealer and ask for active charcoal filters. The filters should be fitted to the extraction assembly inside the hood, by centring them and rotating them 90 degrees, until they click into place (fig. To perform this operation, first remove grille D (fig. The anti-grease filter is used to trap any grease particles suspended in the air, therefore is subject to saturation (the time it takes for the filter to become saturated depends on the way in which the appliance is used). The acrylic filter, which is found resting on the grille, should be replaced when the text, visible through the grille, changes colour and the ink spreads; the new filter should be fitted in such a way that the text can be seen through the grille from outside the cooker hood. If the filters do not have any text on them, or if metal filters or aluminium panel filters are used, they should be washed every 2 months in order to prevent the risk of fire. To wash the filters, proceed as follows: - Remove the filter from the grille and wash it using a solution of water and neutral liquid detergent, leaving the dirt to soften. - Rinse thoroughly with warm water and leave to dry. the metal filters and/or aluminium panel are also dishwasher safe. If the filters are made using aluminium, or if an aluminium panel is used, after a few washes the colour may change. This does not mean they have to be replaced. If the replacement and washing instructions are not followed, the anti-grease filters may present a fire hazard. The active carbon filters are used to purify the air which is released back into the room. The filters are not washable or re-usable and must be replaced at least once every four months. [. . . ] By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e. If key D is pressed the "clean air" function is deactivated and the motor moves to the 2nd speed straight away. by pressing key B the function is deactivated). (*) The "automatic stop timer" delays stopping of the hood, which will continue functioning for 15 minutes at the operating speed set at the time this function is activated. [. . . ]