User manual CANDY CBT63 X

[. . . ] It will always provide useful information on the extractor and will help other people to use it. * Before using the extractor for the first time, you must observe the installation and connection instructions. * Do not switch on the extractor if the electricity cable is worn or has cuts or if there are signs of deterioration around the control panel. [. . . ] * To install the charcoal filter, the motor anchorage is made to coincide with the anchor points of the activated charcoal filter and turn it clockwise. * The carbon filter lasts from three to six months depending on the particular conditions of use. * The activated carbon filter can neither be washed nor regenerated. Once it is exhausted, it must be changed. * To replace exhausted filters with new ones, withdraw the old one in the reverse order to that of installation. Before carrying out any cleaning or maintenance activities, ensure that the extractor is disconnected from the mains. To carry out cleaning and maintenance, follow the Safety Instructions. To withdraw the filters from their locations release the anchoring points. Clean the filter, either by putting it in the dishwasher (see notes) or leaving it standing in hot water to simplify the removal of grease or, if wished, by means of special sprays (protecting the non metallic parts). Notes: cleaning in the dishwasher with aggressive detergents may blacken the surface of metallic parts, without this affecting its gas retaining properties. The filter must be cleaned at least once a month depending on how often the extractor is used. It must be remembered that grease is deposited in the extractor when cooking, whether it is switched on or not. * Take care to disconnect the mains beforehand and that the bulbs to be replaced are not hot. Although venting to the outside is recommended, activated carbon filters may be used, which allow the gas to be returned to the kitchen through the outlet pipe. IIf you wish to exchange the front for one matching the kitchen units, follow the following instructions (Fig. * Remove the screws (T) that support the front I* Install the new front fixing it with the same screws that held the old one. To fix the extractor to the kitchen unit the pattern on fig. The lower part of the extractor must be located at a minimum height of 60 cm above the hob for electric cookers and 65 cm for gas cookers. [. . . ] If the cooker hood is installed for use above a gas appliance then the provision vor ventilation must be in accordance with the Gas Safety (Installation & Use) Regulations 1984 and the relevant Building Regulations. Detailed recommendations are contained in the following British Standard Codes of Practice BS6172, BS5440 and BS6891 Current Edition. This apparatus has the marked CEE in conformity with Standard 2002/92/EC of the European Parliament and the Council about remainers of electrical en electronic apparatuses. [. . . ]