User manual CANDY CCE119X

[. . . ] Before connecting the model to the electricity network: - Control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. if in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. -This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. [. . . ] If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. Fixing to the wall: Drill the holes A respecting the distances indicated (Fig. Fix the appliance to the wall and align it in horizontal position to the wall units. When the appliance has been adjusted, definitely fix the hood using the screws A (Fig. For the various installations use screws and screw anchors suited to the type of wall (e. If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. Fixing the decorative telescopic flue: Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance is to be installed in the ducting version or in the version with external motor, prepare the air exhaust opening. Adjust the width of the support bracket of the upper flue (Fig. Then fix it to the ceiling using 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Connect the flange C to the air exhaust hole using a connection pipe (Fig. Insert the upper flue into the lower flue and rest above the frame. Extract the upper flue up to the bracket and fix it with the screws B (Fig. To transform the hood from a ducting version into a filtering version, ask your dealer for the charcoal filters and follow the installation instructions. Filtering version: Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. To assemble the filtering flue refer to the instructions contained in the kit. If the kit is not provided, order it from your dealer as accessory. The filters must be applied to the suction unit positioned inside the hood. They must be centred by turning them 90 degrees until the stop catch is tripped (Fig. We recommend that the cooker hood is switched on before any food is cooked. We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air. The effective performance of the cooker hood depends on constant maintenance; the anti-grease filter and the active carbon filter both require special attention. [. . . ] man må kvitte seg med apparatet slik lokale regler for avsetting og resirkulering tilsier. For nærmere informasjon om behandling, gjenvinning og resirkulering av dette produktet må man kontakte det lokale avfallsselskap, offentlig kontor med ansvar for søppelinnsamling eller butikken der produktet ble kjøpt. For sikker bruk må man derfor sørge for tilstrekkelig ventilasjon av lokalet. Antifettfilteret brukes til å samle opp alle fettpartikler som finnes i lufta, og dermed er det utsatt for metning (tiden det tar for at filteret blir fullt avhenger av måten apparatet brukes på). [. . . ]