User manual CANDY CD 623 623X

[. . . ] EN User instructions CD 623 CD 623 X Congratulations!Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability. Candy manufacture a vast range of domestic appliances: washing machines, washer/dryers, cookers, microwave ovens, ovens and hobs, refrigerators and freezers. Ask your dealer for the catalogue with the complete range of Candy products. [. . . ] It is advisable to load plates of the same size together in order to utilize maximum basket capacity. Plates may be loaded in a single row (Fig. It is advisable to load large plates (approx. 27 or more cm) slightly tilted towards the rear to facilitate introduction of the basket into the machine. Salad bowls and plastic bowls may also be loaded on the upper basket. It is advisable to block these in place so that the jets of water do not make them overturn. The upper basket has been designed to offer maximum flexibility in use and can be loaded with up to 24 plates on two rows, up to 30 glasses on five rows or a mixed load. Using the lower basket Saucepans, oven dishes, tureens, salad bowls, lids, serving dishes, dinner plates, soup plates and ladles can be loaded on the lower basket. Place the cutlery in the plastic cutlery holder with the handles pointing upwards. Place the cutlery holder on the lower basket (fig. 3), making sure that the cutlery does not get in the way of the rotating arms. 1 A standard daily load is represented in Figs. 1) A = soup plates B = dinner plates C = dessert plates D = saucers E = cups F = glasses E A B C D F 2 A B C D GE F Upper basket (Fig. 2) A = soup plates B = dinner plates C = dessert plates D = saucers E = cups F = glasses with stems G = glasses H = single section cutlery basket H 3 D F AG Lower basket (Fig. 3) A = medium-sized saucepan B = large saucepan C = frying pan D = lids E = tureens, serving dishes F = cutlery G = oven dishes B E C Please load the dishwasher sensibly to ensure the best wash results. 12 13 12 international place load (Ref. Correct loading for the upper basket is indicated in Fig. 7) The cutlery basket is made with two detachable parts which will enable various loading options. The two parts can be detached by sliding the left section away from the right section. 4 G E C D C A F B C I Upper basket (Fig. 4) A B C D E F G H I L = 5 + 5 + 2 glasses = 12 saucers = 4 + 4 + 4 cups = small bowl = medium bowl = large bowl = 1 + 1 forks = 1 + 1 serving spoons = 3 + 3 + 3 + 3 dessert spoons = 3 + 3 + 3 + 3 teaspoons H H L 5 Q M M O P N N Lower basket (Fig. 5) M N O P Q = = = = = 8 + 4 soup plates 11 + 1 dinner plates 12 dessert plates serving dish cutlery Cutlery basket (fig. 6) 6 R Place the side racks in the lower position and fill with 6 + 6 knives(R); in the spaces left insert cutlery with the handles down. Take care not to load more than two different types of cutlery in the same compartment. 14 15 Information for the test laboratories. General programme comparison (see programmes selection) Ref. EN 50242 Standards: 1) Upper basket position: low 2) Normal load 3) Shine setting: 5 4) Amount of detergent: ­ 8 gr for pre-wash ­ 22 gr for wash. 4 3 Filling the rinse aid container The rinse aid container can be found to the right of the detergent container: it has a capacity of about 130 ml (Fig A "3"). [. . . ] If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze. Wait until the temperature rises above zero and then wait for about 24 hours before starting up the dishwasher. 1 1b 2 20 21 Description of the controls E Attention This dishwasher is equipped with an anti-overflow safety device which works even when power is switched off, and if the water level is too high the supply will automatically be closed off. Important To ensure the correct operation of the anti-overflow safety device, it is recommended not to move or to tilt the dishwasher during operation. If it is necessary to move or to tilt the dishwasher, first make sure the washing cycle is finished and that no water is left in the tank. AB C D Selecting the programme and special functions Use in conjunction with programme guide To set the programme, turn the dial clockwise until the pointer ( ) indicates the symbol of the required programme on the control panel. [. . . ]