User manual CANDY CD 797 SMART

[. . . ] Remember to post part A of the guarantee certificate within 10 days of the purchase date. Part B should be filled in and retained by you, to be shown to the person from the Technical Assistance Service if required. You should also keep your sales receipt. Programme selection button Half load button Salt level indicator light EN 50242 place load Capacity with pans and dishes Water supply pressure Fuse Power input Supply voltage 12 8 people Min. [. . . ] Use in conjunction with programme guide Setting a programme Press the On/Off button I ; the 5 programme selection indicator lights start flashing to show that the machine is waiting for a selection to be made. Press the Programme Selection Button Pr and the indicator light for the heavy wash programme will start flashing. set the required programme by pressing the Programme Selection Button again within 5 seconds. When then light for the required programme starts flashing, and when the audible signal has sounded (if it has not been deactivated) the programme will start automatically. And the machine will automatically empty the water; wait for the audible signal, after which the new programme can be set. Before starting a new programme, you should check that there is still detergent in the dispenser. The water softener can treat water with a hardness level of up to 90°fH (French grading) or 50°dH (German grading) through 6 settings. Activating and Deactivating the audible signal The audible signal function can be deactivated in the following way: keep the Programme Selection Button Pr pressed in for a few seconds and at the same time press the On/Off button; if the three indicator lights "INTENSIVE programme", "DAILY programme" and "RAPID 32' programme" are illuminated, the audible signal is activated. By pressing the Programme Selection Button Pr again, the "UNIVERSAL programme" and "ECO programme" lights will come on, which means that the audible signal has been deactivated. Attention This dishwasher is equipped with an anti-overflow safety device which works even when power is switched off and and if the water level is too high the supply will automatically be closed off. Important To ensure the correct operation of the anti-overflow safety device, it is recommended not to move or to tilt the dishwasher during operation. If it is necessary to move or to tilt the dishwasher, first make sure the washing cycle is finished and that no water is left in the tank. EN 50242 Standards: 1) Upper basket position: low 2) Normal load 3) Shine setting: 5 4) Amount of detergent: ­ 8 gr for pre-wash ­ 22 gr for wash. Once a day - for heavily soiled pans and any other items that have been left all day for washing. Once a day - for normal soiled pans and any other items that have been left all day for washing. Suitable for heavily soiled items that are to be washed straight after a meal. Quick wash for dishes which are to be washed immediately after the meal. Short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load. [. . . ] Short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load. Wash with soaking cycle (Prewash) If setting the INTENSIVE wash programme, a second dose of about 20 gr of detergent must be added to the machine in the prewash section of detergent compartment (2). The water-stop device protects against water damages caused by leaks on the fill hose which could develop due to natural ageing of the hose. In the water-stop system the leaking water fills the corrugated hose and activates a stop valve which cuts off the water supply to the machine. [. . . ]